How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask -Brad- Your Own Question
-Brad-, Dodge Dealership Tech
Category: Dodge
Satisfied Customers: 7828
Experience:  16 Yrs Chrysler/Dodge Technician. ASE Master Certified(L-1)
Type Your Dodge Question Here...
-Brad- is online now
A new question is answered every 9 seconds

I have no power to the coil then we I let my truck sit about

Customer Question

I have no power to the coil then we I let my truck sit about half hour it starts
Submitted: 1 year ago.
Category: Dodge
Expert:  -Brad- replied 1 year ago.

Good evening and welcome to JustAnswer!!

Have you replaced the crankshaft sensor yet?

Customer: replied 1 year ago.
No not yet
Expert:  -Brad- replied 1 year ago.

Thanks for the reply!!

The crankshaft sensor is mounted in the bellhousing and it's job it to tell the PCM where the crankshaft is positioned and where #1 cylinder is.. It's a common issue for it to fail which will cause you to have no spark until it cools down. I'm betting it's bad and if you could connect a scantool to monitor it and check codes you could verify that, but it's the most common issue we see and I think it will fix you up..

Also I would advise to use a OEM sensor because the aftermarket sensors have a high failure rate..

Glad I could help and thank you for the positive rating,


Customer: replied 1 year ago.
Thank you so much i will replace in the morning
Expert:  -Brad- replied 1 year ago.

You are very welcome!!

Don't forget follow up questions are free of charge if you need anymore assistance...

And thank you for the positive rating,


Expert:  -Brad- replied 1 year ago.

Just checking to see if you need anymore assistance,