How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Paul M ASE Master Your Own Question
Paul M ASE Master
Paul M ASE Master, ASE Master Tech
Category: Dodge
Satisfied Customers: 4684
Experience:  Ase Master Tech 20+ Years
Type Your Dodge Question Here...
Paul M ASE Master is online now
A new question is answered every 9 seconds

Dakota: 2000 Dodge Dakota - Wipers, radio and turn signals

This answer was rated:

2000 Dodge Dakota - Wipers, radio and turn signals all stopped working at same time. I drove the truck to take care of business and when I returned the truck started fine but no wipers, radio or turn signals. All fuses for above are ok. battery cable connections are clean and tight, battery voltage in acceptable range. Pulled neg. battery cable to reset system but problem still exists. Have had no problem with any of the above until now.

Hello I'm Paul and I will help you with an Answer to your Question


all the systems that have gone out are fed by the same wire from the Ignition Switch

I am attaching the wiring diagram for the power distribution circuit that shows this

Click here to view power Distribution Circuit

in diagram 2 on the right side of ignition switch you will see the Black Wire with White Stripe...(G)

this wire feeds Fuse #10 , #6 , #8 and #15 (as seen in diagram 3)

you need to test for power into the ignition switch on the Red Wire and the Pink With Black

if you have power coming into the switch but no power to the Black with White stripe with the key in the RUN (On position) the Ignition switch has failed

I would suspect the Ignition switch is bad but run the above test to confirm

Remember to rate my answer positive so I get credit for my help.


If you need more help just log in to the site and reply the question will remain for follow up.


Customer: replied 4 years ago.

Thanks Paul, I got the diagrams and fully understand your instructions. I will get into it tomorrow. Will let you know my findings.

ok I'll be around in the afternoon let me know how you make out


remember to rate my answer so I get credit for my help



Paul M ASE Master and other Dodge Specialists are ready to help you
Hi Richard

I'm just following up with you to see how everything worked out?

Please remember to rate my answer positive so I get credit for my help.

If you need more help let me know


Related Dodge Questions