How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 22985
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

where is the crankshaft position sensor on a 2000 Dodge Ram

Customer Question

where is the crankshaft position sensor on a 2000 Dodge Ram 2500 diesel
Submitted: 8 years ago.
Category: Dodge
Expert:  sprinkles08 replied 8 years ago.
Hi. The crank sensor on your truck goes into the block behind the starter. You have to remove the starter, and then you can remove the sensor. I would recommend removing the starter and spraying the sensor down with a ton of penetrating oil. They corrode into the block very bad, and are known to break off in the block when you try to take them out.
sprinkles08 and 5 other Dodge Specialists are ready to help you
Customer: replied 8 years ago.
Thank you...will i need a special tool to remove the starter?
Expert:  sprinkles08 replied 8 years ago.
No you don't. The starter has 3 10mm 12 point bolts that hold it on, nothing major. The crank sensor also uses a 10mm bolt. Its a really simple job, except for the possibility of it breaking off.