Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

I have a 2005 case skidsteer 450, it will start up with no…

Customer Question

Hi , I have...

Hi , I have a 2005 case skidsteer 450 , it will start up with no problem, but it takes 40-50 minutes in order it to release button for it to move :: could this be a glow plug problem….?.

Mechanic's Assistant: Hi. OK. Is there anything else the Construction Mechanic should know before I connect you? Rest assured that they'll be able to help you.

No all good on my question

Submitted: 3 months ago.Category: Construction and Road Equipment

Show Less

Ask Your Own Construction and Road Equipment Question

Answered in 8 minutes by:

2/12/2023

Mechanic: Curtis B., Technician replied 3 months ago

Curtis B., Technician

Category: Construction and Road Equipment

Satisfied Customers: 45,212

Experience: Technican turned service manager with multiple lines of equipment and rental units.

Verified

Relay timer.will not affect the release of the drive /park brake brake release.

Customer reply replied 3 months ago

Hi , Curtis so why does my case 450 take 30-40 min to release to power hydraulic. I mean also move ..?what’s the answer?..

Mechanic: Curtis B., Technician replied 3 months ago

Bad switch? Does the park brake lite go out? What changes from start till it releases?

Customer reply replied 3 months ago

Park brake light comes on ,when I start , then it goes off in 30 -40 min , then machine runs fine ::::Bad what switch .???

Mechanic: Curtis B., Technician replied 3 months ago

Release switch or park brake switch?

Customer reply replied 3 months ago

Ok ; you wouldn’t happen to have part number??your saying these switches or switch takes time to warm up ??

Mechanic: Curtis B., Technician replied 3 months ago

Sounds like a circuit breaker that is throwing and then coming back on.8 and 17.

Customer reply replied 3 months ago

Ok , that's more my speed . I replaced the entire push buttons last year . And all was well .. now just a lot of time waiting for it to move .8-17 is the fuse or relay ?

Mechanic: Curtis B., Technician replied 3 months ago

Both are circuit breakers.

Customer reply replied 3 months ago

Are these located on right and left side by arm rest . By heat and relays ?

Mechanic: Curtis B., Technician replied 3 months ago

Switches May be bypassed, did they have voltage to them ?

Customer reply replied 3 months ago

Located? On my 05 case 450 ?

Mechanic: Curtis B., Technician replied 3 months ago

Sorry, wrong answer, got to many going on..Sorry.Circuit breakers will be in panel.

Customer reply replied 3 months ago

Mechanic: Curtis B., Technician replied 3 months ago

Was this answer helpful?

Yes

How JustAnswer works

Describe your issueThe assistant will guide you

Chat 1:1 with a mechanicLicensed Experts are available 24/7

100% satisfaction guaranteeGet all the answers you need

Related Construction and Road Equipment Questions

I have a Case 450 series 2 skid steer and the dogs on the

I have a Case 450 series 2 skid steer and the dogs on the bucket will not release. You can hear them function, but they will not release, with no movement when they are functioned. … read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

I need to remove the injection pump from my case 465

I need to remove the injection pump from my case 465 skidsteer, I can't find any how videos or write ups. … read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

Caterpillar 277B skidsteer that has a crank no start in cold

Caterpillar 277B skidsteer that has a crank no start in cold weather. Unit fails start unless given a slight shot of starting fluid. And yes I did verify the glowplugs weren't getting powered up. I'm … read more

catmastertech

Field service technician

Vocational, Technical or Trade Scho

1,336 satisfied customers

I have a Case TRV-380 and it will not power on from the

I have a Case TRV-380 and it will not power on from the Instrument cluster. Received a new cluster but it apparently has to be programmed and I can't find anything on how to do that. … read more

Bobcat Master

self-employed

Diesel technology

64 satisfied customers

First question I have is: what type of online service do you

First question I have is: what type of online service do you offer and what is the cost for this service? Thank you kindly. … read more

Wayne

Journeyman

Vocational, Technical or Trade Scho

1,478 satisfied customers

I have a CASE 450 SKIDSTEER I hear the relay clicking in the

I have a CASE 450 SKIDSTEER I hear the relay clicking in the fuse panel to the left but nothing else happens when I turn the key.....??? … read more

Heavy Equipment Tech

Heavy equipment mechanic

159 satisfied customers

On a cat 289d skidsteer. I replaced the hydraulic fan motor.

On a cat 289d skidsteer. I replaced the hydraulic fan motor. While waiting on parts I plugged the 2 hoses to and from the fan motor so I could start it and take the forks off. One fan motor line Did t… read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

I have a direct short blowing my 40 amp main fuse. Is there

I have a direct short blowing my 40 amp main fuse. Is there a common problem with this and where do I start checking for the problem. I replaced the ignition switch and that was not the problem. Thank… read more

Curtis B.

Technician

Associate Degree

45,212 satisfied customers

2015 case sr130......i changed the ele.fuel pump on the

2015 case sr130......i changed the ele.fuel pump on the skidsteer cause it got noisy.....changed it and unpluged brain to get access to bolts....got it all hoocked up wouldnt turn over... well finally… read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

I have a case skidsteer 450, it wont crank, I can hear the

I have a case skidsteer 450, it wont crank, I can hear the selenoid click when I try to start it. … read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

I have a case 450 skid steer, tier 3, sn. N9m400853. The

I have a case 450 skid steer, tier 3, sn. N9m400853. The question I have, is where is the switch to go from hi flo to lo flow, is the skid steer a standard flow? The switch, … read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

Case 450ct skidsteer. sit in seat, instrument cluster lights

case 450ct skidsteer. sit in seat, instrument cluster lights up normal, pull lap bar down, start engine, press button to release park, light goes off then comes right back on and at the same time the … read more

Jeremy

Diesel Diagnostic Technician / Expert

Bachelor's Degree

1,511 satisfied customers

My L160 skidsteer will not start battery check show good

My L160 skidsteer will not start battery check show good good volts, hour meter flashes & beeps showing "volts 0.01" than goes back to showing usage hours. this happens when I turn the key off and on … read more

Curtis B.

Technician

Associate Degree

45,212 satisfied customers

Have an older Bobcat 643 Skidsteer, had to have some engine

Have an older Bobcat 643 Skidsteer, had to have some engine repairs done after which everything was working fine. Then a problem with turning left and right, would move forward and backwards but would… read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

i have a 2005 cat 247B with a glow plug problem. I have not

i have a 2005 cat 247B with a glow plug problem. I have not removed and tested plugs yet. However I do not have power to the glow plugs when i depress the glow plug switch. Fuses test good but not sur… read more

Wayne

Journeyman

Vocational, Technical or Trade Scho

1,478 satisfied customers

Hi: I have a 248 High Flow Skidsteer that just lost all electrical power while cranking

Hi: I have a 248 High Flow Skidsteer that just lost all electrical power while cranking to start. I was pressing the glow plug button at the time, and everything suddenly went dead. No indicator light… read more

catmastertech

Field service technician

Vocational, Technical or Trade Scho

1,336 satisfied customers

I have a bobcat A300 skidsteer i was using the AWS mode and

I have a bobcat A300 skidsteer i was using the AWS mode and the right rear wheel stuck in the turn position and wont straighten even when i take it out of AWS and put it in skidsteer mode - is there a… read more

Wayne

Journeyman

Vocational, Technical or Trade Scho

1,478 satisfied customers

i have an 03 262b skidsteer. not long ago i pushed button to

i have an 03 262b skidsteer. not long ago i pushed button to disingage parking brake & turn on hydraulics, went a fiew feet & stopped, push button again & took off. repeated this severl times, then ha… read more

Daniel Wilson

Associate Degree

1,345 satisfied customers

Disclaimer: Information in questions answers, and Show Less

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.
Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!
AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.
GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.
JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.
EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.
RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.
DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Technician

45,212 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Journeyman

1,478 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Engine Expert

578 satisfied customers

I am ASE Master Certified.

dieseldan55

Mechanic

300 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Technician

97 satisfied customers

24 years of experience diagnosing & repairing

cumminsdr

Mechanic

70 satisfied customers

Cummins field tech

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

< Previous | Next >

Show MoreShow Less