I have a troubleshoot a vermeer ctx100 mini skid steer. I…

Hi, My name is***** will be glad to try to help. We can follow up as needed on here. Professionals are not employees of the site but users of the site and help on here as time allows depending on their daily schedule.Sorry to hear you're having these concerns with this machine. Where this machine runs off of Dual axis pilot controls for travel,You will want to make sure that there are no problems with either of the joysticks and control valves for your pilot controls. If there is no trash or debris in the valves that would cause them to malfunction, I would check your main control valve for any trash or debris that would cause them to malfunction and then have your flows and pressures tested in order to confirm whether or not they are within the OEM specifications covered in this machines model and serial number service book.Check and verify that they are both the same on both sides. You may even be able to swap control valve lines between right and left sides to see if the problem follows the joysticks or if it follows the control valve side of the circuit. If no mechanical problems are found, you will likely need to have your relief valves, pressures and flow adjusted in accordance to the service book. If they are both the same but one drive motor is continuously traveling slower than the other, there could be a problem with one of the drive motors if you have confirmed pressure and flow is the same on both sides. I hope you find this information helpful. Reply back with the results of these checks if any further help is needed. It is a pleasure to help anyway I can.