Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

Related Construction and Road Equipment Questions
I've have a 140M SN / B9M00518 I am having transmission
Hello. I've have a 140M SN / B9M00518 I am having transmission shifting issues but with no codes present. When I go to live data and look at gear engagement. The operator display and and live date gea… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,327 satisfied customers
Champion 740A grader series 2 1985 model roughly, after
Champion 740A grader series 2 1985 model roughly, after running the machine; hydraulic fluid overflows out the tank vent.… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I have a jd 410 with no hydraulics, i checked the screen
hi steve i have a jd 410 with no hydraulics, i checked the screen filter in tranny, looks like it was put in yesterday. i hammered on the clutch linkage the next day and it ran for 5 minutes. got it h… read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
Ellp Dan. Sorry for my english ,is not very good, the grader
sorry for my english ,is not very good, the grader is JD 770-A … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I have a 99 model, 720a champion motor grader, jus got it
I have a 99 model , 720a champion motor grader, jus got it actualy ,, my qst is ,, my turn table will not turn ,it tryn too but am i missing a switch to unlock turn table or is there a manual lock, or… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I've got a Cat 416 (SN#05PC05983) transmission (GN#6y2598
I've got a Cat 416 (SN#05PC05983) transmission (GN#6y2598 SN#B80413). It won't go forward or reverse. I've cleaned the screen (which got me back up in going in the past, replaced the oil and filter. The linkage seems good. I pulled the neutral solenoid and made sure the pin is i retracted(I've left it disconnected). I removed the transmission control group, checked I'll springs and orifices, that all looked good. I did the pressure tap tests with these results (all are in PSI) Forward clutch 35, reverse clutch 55, pump @ idle 140 idle/[email protected], torque inlet 30 @ idle/[email protected] 1800, torque outlet 50, coolant 15. Can you tell me what these readings indicate? Much appreciated, AJ … read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
1975 ih backhoe only goes in reverse. Was working fine. lost
was working fine. lost a hose. replaced hose but worked fora couple hours with low fluid. forward stopped functioning - no noise, no warning. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
I have a Cat 163H that won't go in reverse in any gear. All
I have a Cat 163H that won't go in reverse in any gear. All gears going forward work fine. Tried swapping solenoids on the control valve still no reverse. All pressures check good on the test ports on… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,327 satisfied customers
I have recently purchased a 1978 terex 72-31B wheel loader.
I have recently purchased a 1978 terex 72-31B wheel loader. It is really sluggish to start and in 20 minutes will not move at all, although motor sounds great and all filters have been changed, and pi… read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
I got a champion d600 graded with Detroit and a drmco 9138
I got a champion d600 graded with Detroit and a drmco 9138 transmission I was pushing some dirt and nothing hard and I raised the blade and stepped on clutch put it in reverse and let the clutch out w… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I have a Terex 72 31 front end loader. Two problems. It has
I have a Terex 72 31 front end loader. Two problems. It has trouble turning and has problem getting going, forward and back. Could it be a hydraulic pump?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
We have a 2005 Volvo Motor Grader G710B, with 8400
Hi we have a 2005 Volvo Motor Grader G710B, with 8400 Transmission and Controller. The Grader will not operate when either FORWARD or REVERSE is selected. The Controller display is functional and, err… read more
dieseldan55
dieseldan55
Mechanic
Vocational, Technical or Trade Scho
299 satisfied customers
I have a john deere 310a backhoe that i have put a rebuilt
i have a john deere 310a backhoe that i have put a rebuilt engine engine in i now have the machine running, however the hydraulics are not coming up. the machine set or 4 yrs. i covered the lines to t… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
Man I have a question on a 928g loader I have been doing
Man I have a question on a 928g loader I have been doing some test on the transmission I need a little bit of direction. Here are some of the test results on pressures at the test ports cold Port G is… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I have a Champion 730A Series IV grader and the hydraulic
I have a Champion 730A Series IV grader and the hydraulic pump started going out so I had it rebuilt. While the pump was out being rebuild we decided drain the fluid and clean out the hoses and tank a… read more
dieseldan55
dieseldan55
Mechanic
Vocational, Technical or Trade Scho
299 satisfied customers
I have a JD 670B ,it will not move back or forwards and has
I have a JD 670B ,it will not move back or forwards and has lost its hydraulics. Do they have a clutch type system or a rubber drive, or both ? Do we need to take the motor out to check these drive pa… read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
John Deere 772CH Grader how much charge pressure should i have
John Deere 772CH Grader how much charge pressure should i have for the six wheel drive system. we have no torque when front wheels are on the ground. Has had new transmission and charge pump installed… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
Hi, We are considering buying a Champion 720A motor grader,
Hi, We are considering buying a Champion 720A motor grader, Detroit turbo 2stroke diesel, I'm concerned about the final drive being through a torque converter and no 1st gear in high or low range! Wha… read more
Curtis B.
Curtis B.
Technician
Associate Degree
44,247 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

44,247 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

1,298 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

578 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

299 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

85 satisfied customers

24 years of experience diagnosing & repairing

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

22 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x