Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

Related Construction and Road Equipment Questions
Deere 450j runs fine, stopped moving with trouble code f423
John Deere 450j runs fine, stopped moving with trouble code f423 and f93c … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
13,009 satisfied customers
Have a Taceuchi TL10. Suddenly, will not start. I have a
Have a Taceuchi TL10. Suddenly, will not start. I have a short video of what the control panel is doing. Antifreeze. Full bolt above 12.5. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
How familiar are you with JD 4020 24 volt systems? deere
how familiar are you with JD 4020 24 volt systems? … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a 2001 JD 270 skid steer, with 2-speed. JD 270 skid
I had both final drives replaced. And it was working fine briefly after install, but after a short test drive, the 2-speed stopped working. Tested the switch, and all other electrical components, and the switch seemed to have gone bad. Skid steer serial number: KV0270B270977 I'm curious if this could be an electrical issue as everything seems to test out electrically with the circuit for the 2-speed switch. But, I'm also concerned that the 2-speed hydraulics and the brake hoses might be switched. Would this allow the 2-speed to work momentarily, each time it was ran? Also, the brakes still don't function even after install of the new final drive motors.… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
What is the interlock override system do on a 257b
What is the interlock override system do on a 257b skidsteer? My indicator light is on and my holley rake attachment is not responding. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
I have jd skid steer 7775. error 03 comes up and the foot
I have jd skid steer 7775. error 03 comes up and the foot pedals are locked. The hyd pressure switch appears to check ok, meaning it is normally closed and opens when started. I have no idea where to … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
New Holland L785 with Ford motor about 1992 vintage. 1)
New Holland L785 with Ford motor about 1992 vintage. 1) Bucket up and down and tilt stop working periodically. Must shut off the machine and restart before there can be any movement. Float also does n… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a 260 skidsteer ID#KV0260A460551 I started the
I have a 260 skidsteer ID#KV0260A460551 I started the machine the other day and it cranked up as normal and was running fine for a couple minutes and then died , with no power to the switch. I have tr… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
13,009 satisfied customers
Hey cat man long time no type . I am working on a cat 330B
Hey cat man long time no type . I am working on a cat 330B with a 3306 Machine SN#6DR02396 I got called to the job today cust states unit cranks but will not start found fuel shut down to be NG instal… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
558 satisfied customers
I have a JD 317 Skid steer. stated in cold weather ran short
I have a JD 317 Skid steer. stated in cold weather ran short time engine stalled. I though fuel gelled. heated machine tried to restart engine cranked did not start bled fuel filter pumped primer. cra… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
Hello Curtis. My name is ***** ***** you have helped me before.
Hello Curtis. My name is ***** ***** you have helped me before. I have a JD 6675 skidsteer and I am having electrical issues. I was driving my skidsteer and it seemed like i had some bad fuel. It was … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a ctl80 that won't start. The stop solenoid engages
I have a ctl80 that won't start. The stop solenoid engages when i turn the key but releases after a few seconds. i replaced the timer and the relay. the fuses are good. if i jumper the engine stop fus… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
I Have a caterpillar 430D 3054C engine serial BNK06284 I just
I Have a caterpillar 430D 3054C engine serial BNK06284 I just replaced the fuel injection pump and when I went to start it I have that it starts and stays running only with the key in the start positi… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,296 satisfied customers
Have L20 turned machine off today stopped running but continued
Have L20 b turned machine off today stopped running but continued to turn over. I put key back in on position and in restarted switched to off position and it continued to turn over. My assumption was… read more
dieseldan55
dieseldan55
Mechanic
Vocational, Technical or Trade Scho
294 satisfied customers
I have a 1979 Cat D3-79U-5583 I replaced the selinoid recently
I have a 1979 Cat D3-79U-5583 I replaced the selinoid recently and I'm still having problems starting(cranking) it. I checked the starter while I had it out and it looked good.(bearings/gear shaft etc… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,296 satisfied customers
I have a 1997 JCB robot that I have had since new. Have a new
I have a 1997 JCB robot that I have had since new. Have a new problem that I can't locate the source. Hydralics quit so I shut it off. Now it won't start. Have good power to switch but starter won't i… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a JD 250 skidsteer ,yesterday I turned the key the the
I have a JD 250 skidsteer ,yesterday I turned the key the the displays lit up and could hear the fuel pump wouldn't start,turned again and starter turned over but sluggish wouldn't start ,tried again … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
13,009 satisfied customers
I have a Carrier APU with a two cylinder Kubota Engine. The
I have a Carrier APU with a two cylinder Kubota Engine. The Starter Drive Remains Engaged after the Engine Starts. Why?… read more
DR.Cummins
DR.Cummins
Field Service
High School or GED
2,377 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Wayne

Wayne

Journeyman

13,009 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

558 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

294 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

42 satisfied customers

16 years of experience

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

20 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

Don

Don

Journeyman

13 satisfied customers

i am a red seal canadian mechanic with thirty years experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x