Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Ask an Expert,
Get an Answer ASAP!

I have a 1991 cus It stars no problem I just won't go into…

Customer Question
I have a 1991 cus...
I have a 1991 cus king It stars no problem I just won't go into gears are back up we were looking for a relay but cannot find it anywere could u please help me thanks
Submitted: 1 month ago.Category: Construction and Road Equipment
Show More
Show Less
Ask Your Own Construction and Road Equipment Question
Answered in 12 minutes by:
3/25/2018
Mechanic: Curtis B., Technician replied 1 month ago
Curtis B.
Curtis B., Technician
Category: Construction and Road Equipment
Satisfied Customers: 30,120
Experience: Technican turned service manager with multiple lines of equipment and rental units.
Verified

Hello! Let's see if we can work together and come to a satisfactory conclusion!

Ask Your Own Construction and Road Equipment Question
Mechanic: Curtis B., Technician replied 1 month ago

Cus king? Make and model correct? Electric golf cart? or ??

Ask Your Own Construction and Road Equipment Question
Customer reply replied 1 month ago
Hi
Mechanic: Curtis B., Technician replied 1 month ago

Cus king? Make and model correct? Electric golf cart? or ??

Ask Your Own Construction and Road Equipment Question
Customer reply replied 1 month ago
Construction King loader
Customer reply replied 1 month ago
1991 construction King loader
Mechanic: Curtis B., Technician replied 1 month ago

Case CK backhoe? Hydraulic shuttle or a mechanical shuttle?

Ask Your Own Construction and Road Equipment Question
Mechanic: Curtis B., Technician replied 1 month ago

Hydraulic shuttle has a kick out valve, to stop travel while you raise boom or shift gears, locate the kickout valve and check it for sticking. Should have switch on floor and on gear shift or hyd control valve lever.

Ask Your Own Construction and Road Equipment Question
Mechanic: Curtis B., Technician replied 26 days ago

I see the question is still open, did you find the problem?

Ask Your Own Construction and Road Equipment Question
Was this answer helpful?
Ask Curtis B. Your Own Question
Curtis B.
Curtis B.
Curtis B., Technician
Category: Construction and Road Equipment
Satisfied Customers: 30,120
30,120 Satisfied Customers
Experience: Technican turned service manager with multiple lines of equipment and rental units.

Curtis B. is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

30,120 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

615 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

495 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

270 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

42 satisfied customers

16 years of experience

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

20 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Related Construction and Road Equipment Questions
Deere 4640 keeps blowing power shift valve gasket between
John Deere 4640 keeps blowing power shift valve gasket between two of the ports. After it blows, pressure is getting to clutch packs and causing drag in all gears except 7 and 8. The only other proble… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a TH 514 telehander. Been working fine but get in it
Been working fine but get in it today and won't go any faster than idle … read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a v155c forklift. after using it for about half a
I have a v155c forklift. after using it for about half a hour the trans starts to slip.if I give it more gas and then let off , it will more a little bit … read more
timothy ratcliff
timothy ratcliff
t3
Vocational, Technical or Trade School
9 satisfied customers
I am working on a 12e motorgrader serial number 99e9553. I
I am working on a 12e motorgrader serial number 99e9553. I am looking for the procedure to adjust he clutch.… read more
Curtis B.
Curtis B.
Technician
30,120 satisfied customers
I have a KX 121 -3 kubota excavator. All hydraulic seems to
I have a KX 121 -3 kubota excavator. All hydraulic seems to be ok but walking is weak on both tracks. After running a bit it barely will turn… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a terex telehandler th0806a serial 8322 8000lb lift
I have a terex telehandler th0806a serial 8322 8000lb lift when u put it in foward or reverse it moves but is real slow in all three gears gets worse after it gets out is their a transmission pump wha… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
How do you remove a heater blower fan on a s205 Bobcat? S205
how do you remove a heater blower fan on a s205 Bobcat? … read more
Jeremy
Jeremy
Technician
Vocational, Technical or Trade Scho
104 satisfied customers
Got cut off-would like to finish this...Another question
Got cut off-would like to finish this...Another question please and I will add another fee to this post. My 350A is a JD made in Germany with a roto-diesel pump. I only have a service manual for a 350… read more
Curtis B.
Curtis B.
Technician
30,120 satisfied customers
Quite awhile ago I took the alternator off of my 5575 skid
quite awhile ago I took the alternator off of my 5575 skid steer. I know where the red wire goes, I khow where the plug in goes and the small wire that has a slip on connection I know where that goes.… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
615 satisfied customers
The track on my yard excavator-Hynduai 210xl-3- keeps
the track on my yard excavator-Hynduai 210xl-3- keeps backing 0ff and has … read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a E70 does this have neg ground or neg positive,
I have a E70 does this have neg ground or neg positive … read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I am looking to buy a gehl 6625 sx skid loader to use
I am looking to buy a gehl 6625 sx skid loader to use cleaning up an old farm site. The owner said one side quit driving all of a sudden so I jacked up that side and it seems like the chain is still o… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
Looking for verification on how to find TDC to adjust valves
Looking for verification on how to find TDC to adjust valves on JD 350A with 152 ci diesel. Procedure is to have #1 cylinder at top and then pin the flywheel. Since 4 stroke, still not comfortable if … read more
Curtis B.
Curtis B.
Technician
30,120 satisfied customers
Do you have a ct d5n transmission expert? Cat. Complete
complete rebuild and now it's banging and the tracks stop between shifting in between gears … read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a Deutz 135 ph about 2003 model and have just
I have a Deutz 135 ph about 2003 model and have just replaced the handbrake cables. The two red warning lights on the dash are now not working. I checked the fuses and also put a tester on the handbra… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
I have a 24V system in my Deere 3020 with a 12V light
I have a 24V system in my John Deere 3020 with a 12V light system. Last spring I blew all my lights out. I bought a 24V to 12V converter to prevent this from happening again. Do I put the converter on… read more
Jeremy
Jeremy
Technician
Vocational, Technical or Trade Scho
104 satisfied customers
I have an 07 420 EIT cat backhoe. the hydraulics quit, the
hi i have an 07 420 EIT cat backhoe. the hydraulics quit, the fuse for the lock out and ride control fuse was blown, im wondering if there is a common spot for this wireing to short out..?? i do not h… read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
Anybody familiar with lm 5040 telehandlers. CD2395 structure
CD2395 structure serial number model is lm 5040 delta … read more
Dan
Dan
Auto Mechanics 1&2/diesel mech
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x