Using a Brush Cutter and work tool lock-out will not enguage…

Hi Gary , I was out on the road for a few hours today. I help on here in between jobs as i am available. Straight 242... so you AUX will only work if you hold the button on the joystick? Try this. Press one of the two auxiliary switches located on the right side joystick and then press the continuous flow switch on the left hand joystick and release. Let me know if you need more help.

Continuous Flow and Interlock Override (27)

Machines that are equipped with Continuous Flow and Interlock Override will support both functions on one switch. Your machine may be equipped with a switch that only supports the Interlock Override function.

Continuous Flow (If Equipped) - The continuous flow control supplies continuous flow of hydraulic fluid to the auxiliary hydraulic circuit without continuously holding the auxiliary hydraulic control. Press on either side of the auxiliary hydraulic control. Press on the bottom of the continuous flow switch and release the continuous flow switch. Immediately release the auxiliary hydraulic control after you release the continuous flow switch. The continuous flow function will not be activated if the operator does not release the auxiliary hydraulic control within one second of releasing the continuous flow switch. Press on either the auxiliary hydraulic control or the continuous flow switch in order to stop the flow to the auxiliary circuit.

Interlock Override (If Equipped) - The interlock override function allows the auxiliary hydraulic circuits to function with the armrest in the RAISED position. First activate the continuous flow function. If the machine is equipped with a single function switch then press the bottom of the switch in order to activate the interlock override. If the machine is equipped with a dual function switch then press the top of the switch in order to activate the interlock override function. In order to turn off the interlock override function and continuous flow function, press either side of the auxiliary hydraulic switch or Interlock Override switch.

NOTICE

Do not leave the machine unattended while you have the interlock override function activated.

Hi Gary, I reached out to another expert with SIS access. By your serial number,

This machine only has ON/OFF hydraulics, no auxiliary functions and no auxiliary ECM. It will not have Continuous Flow / or Override switch either.

It will have Work Tool Lockout switch on the RIGHT console.

If his machine has been modified, or has aftermarket aux hydraulics installed then it will be tough to tell without seeing it.

If it has the C/F and Override switch on the LEFT console, then you should have the Auxiliary ECM under the floor plate.

To verify it is a C/F switch, Remove it and check it for the part number(###) ###-####

I believe it will be ON/OFF/MOMENTARY type switch. The top will latch on for Override then it will latch to center off and the C/F will be momentary on the bottom.

Neither him or I work on these enough to be certain, it could be momentary both ways.

You can also verify the wire colors and numbers.

G982 pink

P993 orange

123 white

M901 yellow

614 purple
200 black

203 black

If the function operates normally other than having to hold the momentary switch, Id wire in a switch for on, off to hold that function.