Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Ask an Expert,
Get an Answer ASAP!

Related Construction and Road Equipment Questions
Have a Taceuchi TL10. Suddenly, will not start. I have a
Have a Taceuchi TL10. Suddenly, will not start. I have a short video of what the control panel is doing. Antifreeze. Full bolt above 12.5. … read more
Dan
Dan
Technician
7,225 satisfied customers
I am working on a Takeuchi TB153 FR. The problem is. SN
Yes, here is the problem. It runs and operates fine, and then the Throttle cut out button does not work and the Coolant/oil temp light comes on. and the glow plug light also stay on … read more
Dan
Dan
Technician
7,225 satisfied customers
2006 takeuchi tl150. When cold.it wont go forward to the
2006 takeuchi tl150. When cold.it wont go forward to the right..left track wont drive forward. Will go backwards and forward left. Run it for several minutes back and forth ..left and trying to go rig… read more
Dan
Dan
Technician
7,225 satisfied customers
What size hydraulic quick connectors do l need for a tl150,
What size hydraulic quick connectors do l need for a tl150 … read more
Dan
Dan
Technician
7,225 satisfied customers
I have a tl8, for some reason this morning it would not
I have a tl8, for some reason this morning it would not start. It appears to have a code 14 displayed. It also has a continuous beeping along with the battery light, oil light and a exclamation point … read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,536 satisfied customers
Just bought a 2005 Takeuchi TL150 with less than 2,000
Just bought a 2005 Takeuchi TL150 with less than 2,000 hours. It was running when it went on the trailer in Maryland and we had it dropped off at a Bob Cat dealership in St. Louis to do a routine serv… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,536 satisfied customers
2006 Takeuchi TBO16 Serial Number 11612702 I purchased the
2006 Takeuchi TBO16 Serial Number 11612702I purchased the Takeuchi TBO16 new and it currently has less than 700 hours of use. The machine is designed with a safety feature, which consists of bypassing the hydraulic system when the control consoles are raised on either side, to get on or off the machine. A few days ago, the safety feature prevented the machine from working at all, leaving me stranded on top of a pile of dirt in the middle of a driveway.We began troubleshooting and first discovered that the safety system fuse was burned out. We replaced it and it immediately failed. We checked the switches that are mounted on the control consoles, they were fine. Takeuchi service suggested putting a higher rated fuse to see if perhaps the control solenoid was pulling more than 10 amps. I tried a 30 amp and white smoke appeared from the solenoid area. We began searching the wiring harness for a short and discovered that when the solenoid was installed at the factory, one of the solenoid wires was crimped against the frame and finally the insulation wore thin and a short occurred.While I was that far into the machine, I replaced both solenoids. One is the safety bypass, the other is for the two speed control. Put the machine back together, the safety system works like new, but I have lost my high speed function. When I press the high speed button on the right track control stick, nothing happens. The rabbit indicator light does not come on and the speed stays in low range.I have the machine back apart and have checked the relays and diodes and every thing else I can think of and have found no problems.Please direct me on where the problem is.James … read more
Dan
Dan
Technician
7,225 satisfied customers
I have a Mustang MTL 20 Skid steer, I just replaced all the
I have a Mustang MTL 20 Skid steer, I just replaced all the relays and now I have an issue with blowing a 30 amp fuse for the control arm, it blows when the machine warms up after about 10 minutes. If… read more
Dan
Dan
Technician
7,225 satisfied customers
I have a takeuchi 175 excavator that I just change the oil
I have a takeuchi 175 excavator that I just change the oil and filter, fuel filter, air filter and belts. I now have the warning light with the triangle and explanation mark in it starts flashing afte… read more
Dan
Dan
Technician
7,225 satisfied customers
I have a 2002 TB070 excavator that worked fine until
Hello, I have a 2002 TB070 excavator that worked fine until a recent rainstorm "cleaned" the inside of the cab. Now it still starts fine, but it won't s/d. Even if you pull the battery terminal. The e… read more
Dan
Dan
Technician
7,225 satisfied customers
I have a tl150 and only the left side track won't move.when
Hi I have a tl150 and only the left side track won't move.when I move the stick I see the pressure line tighten up but no movement. They were moving snow got out of the mechine for a minute got back i… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,536 satisfied customers
I have a cat 345 BL and the hydraulic tank light is on just
Hi I have a cat 345 BL and the hydraulic tank light is on just below the key ignition and the hydraulic tank light is on the display screen I have change the hydraulic filter in the tank as well as th… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,283 satisfied customers
my TL 130 starts and runs -20 seconds then shuts off
my TL 130 starts and runs for 15 -20 seconds then shuts off with the oil pressure light flashing ,oil level is fine what is the problem ?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,536 satisfied customers
I have a takeuchi TL140 that the two speed stays when you first
I have a takeuchi TL140 that the two speed stays when you first start it and warning lights in the dash are flashing . Once you run it for a while the two speed starts working and the lights go off . … read more
Dan
Dan
Technician
7,225 satisfied customers
I Have a caterpillar 430D 3054C engine serial BNK06284 I just
I Have a caterpillar 430D 3054C engine serial BNK06284 I just replaced the fuel injection pump and when I went to start it I have that it starts and stays running only with the key in the start positi… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,283 satisfied customers
I have a New Holland Lx 665 that will start but as soon as
I have a New Holland Lx 665 that will start but as soon as i let go of the key it will stop. It will run in service mode, replaced oil pressure switch, replaced Hydrostatic switch, replaced seat switc… read more
dieseldan55
dieseldan55
Mechanic
Vocational, Technical or Trade Scho
273 satisfied customers
Cat skid 226B, Engine Serial # XXXXX Model # XXXXX Engine
Cat skid 226B, Engine Serial # XXXXX Model # XXXXX Engine was caked with oil/grime on outside left side of motor. Power washed engine and got her nice and clean to look for oil leak. Machine wouldn't … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
650 satisfied customers
takeuchi tl(NNN) NNN-NNNNpark brake is stuck on. hydraulics work
takeuchi tl(NNN) NNN-NNNNpark brake is stuck on. hydraulics work sometimes,more often when very cold near freezing,when the hydraulics function then i can feel the machine torquing with the brakes stu… read more
Dan
Dan
Technician
7,225 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

1,536 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

650 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

517 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

273 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

42 satisfied customers

16 years of experience

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

20 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x