Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

Related Construction and Road Equipment Questions
I have a 2008 model New Holland L190 skid steer loader. It
I have a 2008 model New Holland L190 skid steer loader. It was flipped upside down for two days. I flipped it back over and there does now appear to be any damage to anything. I'm afraid to start it b… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,064 satisfied customers
I am considering buying a used 1999 Kubota r520 loader. It
I am considering buying a used 1999 Kubota r520 loader. It has 3527 hours, it is for sell for 30k list it's model and serial # as UT23797. Are there issues with this loader that you know of? When I go… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,064 satisfied customers
I have a cat 9:50 loader that the end fell into a sand bog
I have a cat 9:50 loader that the Ass end fell into a sand bog hole and was over the engine at one point before I could get myself out with the front bucket . It stayed running and I shut it down once… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
I have a 416C, PIN 4ZN06598. The loader may lift barely
The loader may lift barely inches, no load. It will even fall very slowly if trying to raise it, at times. Also, bucket will hardly tilt up/back, no load. … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
I have a case wheel loader w-14 with a 336BD engine the
i have a case wheel loader w-14 with a 336BD engine the engine starts great and sounds good when running but its low on power and its lazy when you step on the throttle … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
1,024 satisfied customers
Last year I purchased an 820. The front loader hydraulics
last year I purchased an 820. The front loader hydraulics are slow and the pump is a little noisy. Just checking to see what may be the problem and what to do about it. The loader is off right now -- … read more
Bradey V
Bradey V
Certificate
Here is my story, I have a CAT loader 966H serial # A6J01055
here is my story, I have a CAT loader 966H serial # A6J01055 my problem is that when I start the loader after 10 minutes the radiator will start to blowing water. The loader is not under high load or … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,064 satisfied customers
What is best procedure for bleeding air from fuel system on
What is best procedure for bleeding air from fuel system on a 1985 JD 555A front end loader? This one has the fuel lift pump fuel lines disconnected and uses an electrical fuel pump placed above the f… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
I have a 1980 966C Loader. It is leaking from one of the
I have a 1980 966C Loader. It is leaking from one of the nozzles. Will this reduce the power of the loader? Is it an easy fix? Thank you… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
1,024 satisfied customers
Have cat 930 that fuel up the injectors have taken all apart
have cat 930 that fuel up the injectors have taken all apart put back together runs good until you put it to work then it will start to weap fuel again … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
2000year cat 315BL excavator 3046T engine. 9400 hours on
2000year cat 315BL excavator 3046T engine. 9400 hours on machine with good maint history. Loss of hydraulic power. Cat Mechanic turned up main hydraulic pressure relief valve but didn't help. New fuel… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
I OWN A 938G LOADER SERIAL NUMBER CRD00975. THE PROBLEM IS
I OWN A 938G LOADER SERIAL NUMBER CRD00975. THE PROBLEM IS THAT SOMETIMES IT WORKS THE WHOLE DAY WITH NO PROBLEMS, BUT SOMETIMES IT ONLY WORKS 2 OR 3 HOURS AND IT SUDDENLY STOPS, AND IT DOESN´T START … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
Good Afternoon and new question: Same machine Cat 950F II
Good Afternoon and new question: Same machine Cat 950F II Ser. 5SK01471 - - the engine in this machine is hard to start. When cold you have to crank it allot. It will start again right after you shut … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,307 satisfied customers
i have a john deere 710d 1999 backhoe. iwas backing up from
i have a john deere 710d 1999 backhoe. iwas backing up from getting a load of dirt in the loader when the engine sputered and died. i thought that it was out of fuel but when i tried to start it the s… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
I have Hyundai wheel loader HL740-7 and I am having a starting
I have Hyundai wheel loader HL740-7 and I am having a starting issue,the injector pump is rebuilt,the transfer pump is new. The loader will start when shot with ether and run great, but once shut off … read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
Hi There We have assembled a Cat 3304 PC engine for one
Hi There We have assembled a Cat 3304 PC engine for one of our customers. We installed the engine in the loader and started the engine. The engine is only running on 3 cylinders. IF you loosen no 4 in… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,245 satisfied customers
I run a 980c. Normal Diesel consumption is about 19 liters
I run a 980c. Normal Diesel consumption is about 19 liters an hour. Now using up to 35 liters an hour. Color of smoke is normal. Engine temperature is normal 85 degrees. No engine oil dilution has bee… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,245 satisfied customers
I run a 980c. Normal Diesel consumption is about 19 liters
I run a 980c. Normal Diesel consumption is about 19 liters an hour. Now using up to 35 liters an hour. Color of smoke is normal. Engine temperature is normal 85 degrees. No engine oil dilution has bee… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
1,024 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

1,921 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

1,024 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

10,245 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

294 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

44 satisfied customers

24 years of experience diagnosing & repairing

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

22 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x