How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Construction and Road Equipment
Satisfied Customers: 1177
Experience:  Technican turned service manager with multiple lines of equipment and rental units.
Type Your Construction and Road Equipment Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Have a w36 case loader that sat years, cant get sufficant

Customer Question

have a w36 case loader that sat for many years, cant get sufficant fuel to injectors. have performed all the traditional priming and bleeding routines. signs of rust in fuel inlet
Submitted: 2 years ago.
Category: Construction and Road Equipment
Expert:  Curtis B. replied 2 years ago.
I suspect the injection pump is stuck in the off position. What is the injection pump make? CAV /Lucas? If it is a Cav/Lucas , you can remove the upper cover, and check the inner linkage. Look how the kill lever works the linkage, the linkage should pull into the off/kill position, and when the kill cable is pushed in, the inner linkage has to spring back. If you can get the linkage to move and spring back into the run position, you will get the fuel to the injector nozzles.
Customer: replied 2 years ago.
i believe its a bosch
Expert:  Curtis B. replied 2 years ago.
Can you get to the cover that the kill lever would go to. If you can't free up the linkage, so it moves to the open position, you will need to remove the pump for repair.

Related Construction and Road Equipment Questions