Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

Related Construction and Road Equipment Questions
I have a cat 930 loader serial number 41k4218. it stopped
i have a cat 930 loader serial number 41k4218. it stopped moving in all gears. we put a pressure gauge on the filter housing and only getting 40psi in all gears, it is also putting air into the transm… read more
Curtis B.
Curtis B.
Technician
Associate Degree
2,324 satisfied customers
CAT C7, HARD START LOW CRANKING FUEL PRESSURE. HUEY PUMP
CAT C7, HARD START LOW CRANKING FUEL PRESSURE. HUEY PUMP WHEN RUNNING, IF CALLS FOR 11100PSI IT IS 1100 PSI, ZERO PRESSURE FROM LIFT PUMP UNTIL ENGINE IS RUNNING THEN 80 PSI AT TEST PORT, DISCONECT FU… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
CAT C15 jerking at 105km/H, no active codes. Checked fuel
CAT C15 jerking at 105km/H , no active codes. Checked fuel water separator, lot of air in fuel. Drained water separator, found air pressure in fuel. What will cause air in fuel water separator?… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
2007 C9 Cat 335 HP in a Sterling truck. I guess i will ask
2007 C9 Cat 335 HP in a Sterling truck. I guess i will ask the question first and then go into detail. Have you ever seen a issue with the HEUI pump driving the transfer pump drive shaft. Short versio… read more
james Roberts
james Roberts
Maintenance assistant
Vocational, Technical or Trade School
3 satisfied customers
I have a customers 1996 freightliner fertilizer tender truck
I have a customers 1996 freightliner fertilizer tender truck with 3176 cat. Engine goes into a multiple shudder or misses when under load. No codes are stored in ECM, found debris in filter suction li… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 252 Cat Skid Steer. It does not have full power.
I have a 252 b Cat Skid Steer. It does not have full power. when I throttle up it seems like there isn't enough fuel or air supply. I checked the fuel water filter and air filter but the problem still… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,327 satisfied customers
To Cat Man I got a 2007 Pete C15 Cat MXS88670 it jumps like
To Cat Man I got a 2007 Pete C15 Cat MXS88670 it jumps like cutting the switch off & on It does not go dead The Cat shop in B'ham replaced the wiring harness inside the head and the wiring harness on … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a cat 8h dozer 46a with low fuel pressure. have
I have a cat 8h dozer 46a with low fuel pressure. have checked the supply line from tank for free flow and blown air back thru line. changed the primary fuel screen, replaced the fuel transfer pump an… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,327 satisfied customers
I have a c15 catipiller truck engen. It is hard to start,
I have a c15 catipiller truck engen . It is hard to start , like it is loseing prime to fuel filter. I replaced these item . Check valve hand pump transfer pump fuel line from back of head to fuel fil… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
I have a cat 725 articulated truck with a 2001 3176 engine.
I have a cat 725 articulated truck with a 2001 3176 engine. It has been starting everyday with a jump start. Yesterday it started then seconds later sputtered and died. Will not start back up. Changed… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,269 satisfied customers
What would cause a c15 accert engine to surge and vibrate
What would cause a c15 accert engine to surge and vibrate intermittently in high gear? Fuel pressure is. Replaced crankshaft position and harness.… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a CAT C9 with a strange oil pressure problem. I rebuilt the motor about 200 hrs
Hi I have a CAT C9 with a strange oil pressure problem. I rebuilt the motor about 200 hrs ago and now, when you start it, it has around 100psi oil pressure. After 5 minutes, it loses about 1lb per sec… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
2005 c15...when I'm in a pull, the power is cut back & manifold
2005 c15...when I'm in a pull, the power is cut back & manifold psi fluctuates 8-10 psi.. No codes.. It will pull good about 25% of the time..… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
How does fuel get from tank to injectors on a 3406- engine
How does fuel get from tank to injectors on a 3406-B engine at the appropriate pressure required?… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
i have a 3406 e cat that has had low power every since the
i have a 3406 e cat that has had low power every since the head was replaced due to a droped valve. sometimes on exceleration it it has short surges of power, other times it has none. could this be th… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 287b skidd steer and when at full throttle its revs
I have a 287b skidd steer and when at full throttle it's revs up and down what should I be looking for I change fuel filter… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,327 satisfied customers
I have a 2007 T800with a C15 Cat. When using the defroster,
I have a 2007 T800with a C15 Cat. When using the defroster, the engine fan will not cycle on and off. It will only lock on and does not show on the dash that it is on, but if you shut the engine off a… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 3126 cat engine in a 2000freight liner fl60 .Fuel
I have a 3126 cat engine in a 2000freight liner fl60 . Fuel pressure at the bleeder slowly goes up to 30psi. Just Erving it up lowers it. Driving it with any amount of load drops it to 0. I have repla… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

2,324 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

1,298 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

10,344 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

299 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

85 satisfied customers

24 years of experience diagnosing & repairing

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

22 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x