Construction and Road Equipment

Construction and road equipment repair questions? Ask a mechanic ASAP

Connect one-on-one with {0} who will answer your question

Related Construction and Road Equipment Questions
I have a ‘96 JCB 214-2 backhoe perkins 4 cyl, turbo, (lucas
Second Opinion] hello , i have a ‘96 JCB 214-2 backhoe perkins 4 cyl , turbo , (lucas cav fuel injection pump) gets fuel into oil changed oil after 16 hours of operation , it had gained 1.2quarts over… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
I have a ‘96 JCB 214-2 backhoe perkins 4 cyl, turbo, (lucas
hello , i have a ‘96 JCB 214-2 backhoe perkins 4 cyl , turbo , (lucas cav fuel injection pump)gets fuel into oil changed oil after 16 hours of operation , it had gained 1.2quarts over 2.5 gallons of o… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,057 satisfied customers
I have a 1991 case 580 K diesel which lopes on idle speed as
I have a 1991 case 580 K diesel which lopes on idle speed as if some cylinder misfires, causing rpm to vary, but starts to run smooth when rpm increased to 1100 rpm. I thought fuel pump might have air… read more
Fieldtech59
Fieldtech59
370 satisfied customers
I got the head back. Three out of the 6 cups my mechanic put
Good evening Don I got the head back. Three out of the 6 cups my mechanic put in the head were leaking. The damage he did to the head was far enough down that it did not have anything to do with seali… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,306 satisfied customers
I started up theloader up today with the new radiator cap 15
Hey Don I started up theloader up today with the new radiator cap 15 psi. And I put my pressure gauge on it. My pressure gauge Read Close to 15 pounds and it started blowing antifreeze out the overflo… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,306 satisfied customers
Left hydro is jerky it either growls or grabs especially in
left hydro is jerky it either growls or grabs especially in reverse. Hydraulic fluid is on full … read more
Fieldtech59
Fieldtech59
370 satisfied customers
I'm having real problems finding the two bleed screws on the
Hi Steve. I'm having real problems finding the two bleed screws on the injector pump (Lucas CAV) on my JCB 3CX. Any clues? Cheers Jerry … read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
My 404c22 dies out when lifting load in bucket. Jcb 208s,
It got hot for starters when i repaired the hose and refilled antifreeze it continued to run fine until i tried to lift heavy load. So i found aseepage around head i replaced head gasket which fixed the over heating but it still loses power when lifting a heavy load … read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
I have a perkins rather 2300 gen set, Perkins series 2300
Hello, my name is***** have a perkins rather 2300 gen set … read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
Bobcat M# *****(approx 1997)--Has The Peugot XUD9 Diesel
Bobcat M# *****(approx 1997)--Has The Peugot XUD9 Diesel Engine--I Have Completely Rebuilt the Engine--New Pistons, Etc--Everything!!!---I Cannot Get Any Fuel Pressure Out of The Injector Pump!---Pump… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,057 satisfied customers
i have a 2004 bobcat 553 i had it plugged in outside, starts
i have a 2004 bobcat 553 i had it plugged in outside, starts up runs fine, but when i have the motor in full rpms when using the machine the rpms go up and down and seem like the belt is slipping mayb… read more
Fieldtech59
Fieldtech59
370 satisfied customers
Hi. I recently purchased a late 90's D5C dozer with a
Hi. I recently purchased a late 90's D5C dozer with a blown motor ( appears to have thrown a rod). It is equipped with a 3046 turbo diesel which is rated at 95 fwhp. A little hunting around on the net… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,306 satisfied customers
Have a 1989 926e loader. Plowing snow and bolt broke holding
Have a 1989 926e loader. Plowing snow and bolt broke holding injector and it came out through the top pan. Installed new injector and engine started and ran ok. Problem is when I put it in gear it wou… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,306 satisfied customers
I have a JCB 1400B backhoe with extender about a year 1986.
I have a JCB 1400B backhoe with extender hoe about a year 1986. I ran it low on fuel and now it will not run very long and shuts down as though it is starving for fuel. It is half full now, but was ex… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
I have a 2005, 4wd JCB 214 backhoe, vin#SLP214TC5U0905222 with
I have a 2005, 4wd JCB 214 backhoe, vin#SLP214TC5U0905222 with an engine serial number RG380844172529L that will not start. It has about 2,000 hours on it. The problem started with water in the fuel. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,057 satisfied customers
If I had diesel fuel getting in my crankcase before, and I
If I had diesel fuel getting in my crankcase before, and I got my injector pump rebuilt, changed the fuel, put new injectors in, how else can the fuel be getting in the crankcase, is there anyway that… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
Gentlemen,I have an old Wain Roy Backhoe/Loader w/ what I
Gentlemen, I have an old Wain Roy Backhoe/Loader w/ what I believe has a Ford 242 cu in, 4 cylinder Diesel engine. It usually runs well. However, when I started it a week ago, it revved so high I thou… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,921 satisfied customers
Donnie, I have a question about engine coolant temperature
Donnie, I have a question about engine coolant temperature sensor. very frustrating trying to figure this thing out. it has 8 volts going to it. it has 7.4 volts going back to gauge but voltage never … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,306 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

1,921 satisfied customers

Technican turned service manager with multiple lines of equipment and rental units.

Wayne

Wayne

Journeyman

14,872 satisfied customers

worked on many road graders, Bull dozers , skid steers, Rollers

Cat Man

Cat Man

Cat Engine Expert

571 satisfied customers

I am ASE Master Certified.

dieseldan55

dieseldan55

Mechanic

294 satisfied customers

Road Mechanic for Volvo Construction Equipment.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

44 satisfied customers

24 years of experience diagnosing & repairing

Steve

Steve

Mechanic

42 satisfied customers

Heavy Equipment Mechanic for 25 years

JBFixxer

JBFixxer

Mechanic

22 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x