How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete
Pete, Networking Engineer
Category: Networking
Satisfied Customers: 17397
Experience:  CISCO Certified Networking Engineer
30970729
Type Your Networking Question Here...
Pete is online now
A new question is answered every 9 seconds

Need help with Cisco core/access switch config I was trying

Customer Question

Need help with Cisco core/access switch config
I was trying to migrate to a new core switch and apparently had config problems so I tried to roll it back...Since moving the cables back, I can't reach 2/6 access switches, 2 of the remaining 4 that had redundant connections now only have one working and I was getting vlan flapping issues until I shut down one side of the ports. Didn't make any changes to existing core or access switches---think I may have mismatched a couple when I moved the cables and maybe err-disabled. ...otherwise I'm at a loss. NEed to get this back up. Thanks
Submitted: 9 months ago.
Category: Networking
Expert:  Pete replied 9 months ago.

Hi, I'm Pete. Welcome to JustAnswer! I'm reviewing your question now, and will post back with your reply ASAP.

Expert:  Pete replied 9 months ago.

Have you tried power cycling the switches?