Ask Computer Networking Questions and Get Answers ASAP
Try these steps please>
1Make sure you are just seeing screens on the monitor
2 Push the [DVR] button on the remote so you will send the right commands
3 Enter the following seven key sequence in your remote control [FREEZE] [ALARM] [FREEZE] [ALARM] [FREEZE] [MENU] [ENTER]
4 A menu will pop up asking if you wish to do a factory reset
5 You will get a message that says "wait until your system turns off"
6 You will be asked to disconnect the power cable. You should do this for 10 seconds. When your system comes back on you can enter the default login of admin and 4321.