Classic Car

Have classic car questions? Ask an Expert.

Connect one-on-one with {0} who will answer your question

Related Classic Car Questions
I have a 1964 GTO that just started running rough. It feels
I have a 1964 GTO that just started running rough. It feels like it's not running on all cylinders. I changed the spark plugs and wires, but it didn't make any difference.… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
I have a 1967 Thunderbird 390 v-8 with 81 k miles.It is in
I have a 1967 Thunderbird 390 v-8 with 81 k miles.It is in perfect shape.I have replaced the suspension u joints,points,condenser,coil,plug wires,new carburetor , brakes fuel filter,set timing.The eng… read more
Ted G.
Ted G.
Owner
Vocational, Technical or Trade Scho
5,692 satisfied customers
I have a 1974 ford f250 with a 390, the distributor is the
i have a 1974 ford f250 with a 390, the distributor is the points type. I have no spark at the plugs. I was driving home in it and it started acting like it was out of gas. The gauge isn't working at … read more
roybelding
roybelding
ford ranchero gt: 1979 ford..302..edelbrock performer intake
1979 ford..302..edelbrock performer intake and 600 cfm 4bbl carb..vacuum 2nd and electric choke..new cap rotor plugs and wires..new ingnition module..coil ..set and reset timing from 15 to 18 degrees.… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
Chevrolet blazer: hello, I have a new 350 crate motor. very
hello, I have a new 350 crate motor. very hard to start. turn key, came with everything. runs very rough, no power. Summit said to check cap and rotor. I just replaced the whole distributor with a new… read more
Dr. Hamman
Dr. Hamman
Vocational, Technical or Trade Scho
6,151 satisfied customers
Chrysler Newport: Mike, I have done some additional tests and
Mike, I have done some additional tests and found that I am in fact getting misfires at all RPMs, although they are much worse at 1000-1500 RPM than they are at other speeds. I regapped my contacts an… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
Ford Super Deluxe: Have a 1946 ford I can not get spark from
Have a 1946 ford I can not get spark from the coil , every thing is new coil condenser, rotor point's..I ran wire diretly from bat I am using a no resistor coil.… read more
Don - Mo Lurch
Don - Mo Lurch
Owner
Vocational, Technical or Trade Scho
11,764 satisfied customers
Ford Bronco: I have a 1973 Ford Bronco, 5.0 L 302-G. Just converted
I have a 1973 Ford Bronco, 5.0 L 302-G. Just converted points to Pertronix Ignitor about a month ago. Ran fine until last week. Once engine warms up, loss of power, occasional "plinking" sound when ac… read more
Dr. Hamman
Dr. Hamman
Vocational, Technical or Trade Scho
6,151 satisfied customers
56 chevy: master..Previous owner put about 1000 miles..road
I have a 56 chevy with 350 target master crate engine with HEI ignition. Previous owner put about 1000 miles on this engine over a 10 year period. I have put about 1200 miles on the engine since getti… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
75 f-150: rebuilt..mild cam, holley carb, breakless distributor
I have a 75 f-150 with factory 390. Was rebuilt and a few upgrades before i purchased the truck. Engine has mild cam, holley carb, breakless distributor. Problem: stumbles when accelerating. sounds li… read more
RIP ROBERT
RIP ROBERT
OWNER
High School or GED
761 satisfied customers
1970 toyota: tune..condenser, rotor, cap, wires and plugs..timing
I have a 1970 Toyota FJ40 that I bought not long ago. Since the previous owner did'nt take much care with it, I changed all the fluids, and gave it a tune-up (points, condenser, rotor, cap, wires and … read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
Ive got a 1966 Ford Thunderbird, with a rebuilt 390 v8 engine.
I've got a 1966 Ford Thunderbird, with a rebuilt 390 v8 engine. The stock carburetor was replaced with a holley 750, and the jets were taken from #64 down to a pair of #55's on the front bowl. I've pr… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
915 satisfied customers
68 ford: pickup..ve changed..condenser,cap rotor button,and coil
I have a 68 ford pickup with a 390. I can't get it to start. I've changed points,condenser,cap rotor button,and coil. It acts like it's not firing,don't know if it's in time or not. Thank you!… read more
John Phillips
John Phillips
Bachelor's Degree
22 satisfied customers
502 fe: trans..cam is part..timing is set at 10 degrees..fuel pressure
hi, i have a 502 fe.motor+ auo. trans in a 70 chevelle , the motor has a rough ide when you stop at a red light or ?? I used ac delco rapid fire #4 plugs at 0.40 gap ( no help) Then I tried autolight … read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,223 satisfied customers
76 ford 300: plug wires..distributor side of coil wire..jump..bolt
I have no spark in my old 76 ford 300 6cyl, tried checking for spark from plug wires and nothing. I did try (crazy) holding distributor side of coil wire and having son turn over, no shock. Tried new … read more
Jan Andersson
Jan Andersson
Master Tech
Bachelor's Degree
809 satisfied customers
1971 Ford Torino: the radiator..overheating..oil pump..oil pressure
I have a 1971 Ford Torino 500. I've had it for about a month, and all I have had is problems. I replaced the radiator due to overheating problems, a new high flow oil pump because I had no oil pressur… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
72 ford torino: in the car..engine was a 2v model.
I have a 72 ford torino. I have put a 429 from a 71 Mercury in the car. The engine was a 2V model. When I rebuilt the engine I put in a very mild cam from Summit Racing. You really cannot even detect … read more
RIP ROBERT
RIP ROBERT
OWNER
High School or GED
761 satisfied customers
53 ford: rebuilt..it to start! its getting gas, no spark
rebuilt 53 ford jub. everthing new can''t get it to start! it''s getting gas, no spark. new 6 volt bat.hydrometer reads full charge lites will not even come on. battery will turn engine over… read more
Dr. Hamman
Dr. Hamman
Vocational, Technical or Trade Scho
6,151 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Don

Don

Classic Car Mechanic

952 satisfied customers

30 years of experience and we have 4 classic cars our selfs

Mike S.

Mike S.

Classic Car Mechanic

915 satisfied customers

A.S.E. certified with 25+ years experience.

K. Wiggins

K. Wiggins

Classic Car Mechanic

483 satisfied customers

ASE Certified Technician, Associates Degree in Automotive Technology, 20+ years in the trade

Dave Nova

Dave Nova

ASE Technician

416 satisfied customers

ASE Master Certification. GM World Class Certification

Road Side Jerry

Road Side Jerry

Auto Mechanic

280 satisfied customers

classic car mechanic

6v_man_in_12v_world

6v_man_in_12v_world

Restoration Shop Owner

191 satisfied customers

Full service restoration shop specializing in pre-war, brass era, and full classic, but also up to mid-'60s.

Matt

Matt

Engineer

176 satisfied customers

BEng Hons mechanical engineering 20 years repairing my own cars and others, 8 yrs in formula 1 engin

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x