Classic Car

Have classic car questions? Ask an Expert.

Connect one-on-one with {0} who will answer your question

Related Classic Car Questions
F-250 Ranger: 1979 Ford F-250 4X4. Starts fine has a Holley
1979 Ford F-250 4X4. Starts fine has a Holley 90670 truck avenger carb on it. every time I try to free rev the engine it stubbles a little bit but as soon as I put it in gear and give it some gas it f… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,420 satisfied customers
ford f 250: 1967 ford 250 truck 352 cu and 2barrel
1967 ford 250 truck 352 cu and 2barrel carburetor no problems when cold after warmed up will not start?… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
889 satisfied customers
1956 Ford F-250: is a 6 cyl 223..it more drive able On the open roads
I have a 1956 Ford F-250 restored.The engine is a 6 cyl 223 and the rear end ratio is4:88 to 1.I want to change out the engine and rear end to make it more drive able On the open roads. Any ideas? Tha… read more
gmtech1967
gmtech1967
business owner
ASE Master Tech Certification
151 satisfied customers
1979 Ford F-150: start fine..warm..Cant start it again till it cools
truck start fine, then after you drive or warm it up and shut it off. Cant start it again till it cools off. Spark and fuel are good and choke is working properly, 1979 Ford F-150… read more
6v_man_in_12v_world
6v_man_in_12v_world
210 satisfied customers
1973 ford courier: a mazda 1800 & a 4 speed..automatic..rear end..road
I have a 1973 ford courier p/u w/a masda 1800 & a 4 speed but it has a mismatched rearend that belongs to a very small automatic from that year. what rear end will fit my 1800 & 4 speed to give me bet… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
65 ford F-250: im I rebuilt the trans..about 15 minutes..loud
I just did a conversion on a 65 ford F-250 from 4-spd manual to the c-6. I'm I rebuilt the trans, and got it installed and since I had done some motor work also, I had to run the motor at higher rpm o… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
72 f-250: manual transmission..overdrive would bolt..engine block
like i said i have an 72 f-250 with an 360 engine and an 4 speed transmission. i would like to know if a newer manual transmission with and overdrive would bolt up to the 360 engine block… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
77 Ford F-150: I just installed a B&M Shift Kit..reverse
I just installed a B&M Shift Kit in my '77 Ford F-150 and now I only have reverse..? 429 with C6 Transmission… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
889 satisfied customers
F-250: ton..truck and need a left door latch assemblie
I have 1965 3/4 ton f-250 pick-up truck and need a left door latch assemblie. Will a 1960 f-250 door latch work ?… read more
Bluewolf6
Bluewolf6
Commercial Sales Manager
High School or GED
158 satisfied customers
79 Ford: 4x4..headers..pair ive tried hits the motor mounts towers
I have a 79 Ford 4x4. I dropped a 460 in and have been trying to find headers that will fit but cant. Every pair i've tried hits the motor mounts towers… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
889 satisfied customers
1968 volvo 1800: SE..titan or? there is a electrical spark..terminals
Hi, I have a 1968 Volvo 1800S and replacing the old Bosh VR. After wiring in the replacement now available (SE-805) from Tiwan or? there is a electrical spark when touching the battery cables to termi… read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,223 satisfied customers
1977 F-150: that holds the 4 wheel drive stick..linkage..haynes manual
I have a 1977 F-150 and the shoulder bolt that holds theXXXXXstick to theXXXXXlinkage is missing, it doesn't show the bolt in my Haynes manual, I was wondering what size bolt that could be and where I… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
889 satisfied customers
1965 ford f100: carb..what is the points gap and timing for it
I have a 1965 ford f100 with a 240 motor and a single barrell carb what is the points gap and timing for it. Also what is dwell set?… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
889 satisfied customers
1965 ford f 250: automatic transmission..alternator..harness..diagram
hi I have a 1965 ford f 250 with a 240 engine and automatic transmission . the wiring is missing from the alternator to the voltage regulator I have all new parts . the new harness wiring to them but … read more
Don
Don
Classic Car Mechanic
Vocational, Technical or Trade Scho
952 satisfied customers
1973 f-250: it has and what kind off axles and were i could get them
i have two questions one i have a 1973 f-250 highboy with a 460 and i was woundering what kind of transmission it has and what kind off axles and were i could get them at… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
71 f-100: tran..much loss or gain if i swap a 77 3.00 9 rearend
i have 71 f-100 302 c4 tran 3L70 8.7 rearend .how much loss or gain if i swap a 77 3.00 9" rearend… read more
Chris
Chris
Bachelor's Degree
16 satisfied customers
I have 1965 f100 with a 289 engine can you tell me if I can
I have 1965 f100 with a 289 engine can you tell me if I can install a 4spd toploader overdrive transmission with out to much trouble… read more
Tim Basham
Tim Basham
auto repair, shop foreman, tech trainer
Vocational, Technical or Trade Scho
500 satisfied customers
What standard transmission with overdrive will fit behind ...
What standard transmission with overdrive will fit behind my ''76 FE 360 in my ''76 F-100 4x4 shortbed? also a 2sp transfer case?… read more
classictech
classictech
Consultant
Vocational, Technical or Trade Scho
108 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Dr. Hamman

Dr. Hamman

Technician

2,436 satisfied customers

I have 30 years experience repairing, restoring, and customizing cars, and pickup trucks.

Don - Mo Lurch

Don - Mo Lurch

Classic Car Mechanic

994 satisfied customers

Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.

Don

Don

Classic Car Mechanic

952 satisfied customers

30 years of experience and we have 4 classic cars our selfs

Mike S.

Mike S.

Classic Car Mechanic

889 satisfied customers

A.S.E. certified with 25+ years experience.

K. Wiggins

K. Wiggins

Classic Car Mechanic

465 satisfied customers

ASE Certified Technician, Associates Degree in Automotive Technology, 20+ years in the trade

Dave Nova

Dave Nova

ASE Technician

416 satisfied customers

ASE Master Certification. GM World Class Certification

Road Side Jerry

Road Side Jerry

Auto Mechanic

280 satisfied customers

classic car mechanic

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x