Classic Car

Have classic car questions? Ask an Expert.

Connect one-on-one with {0} who will answer your question

Related Classic Car Questions
I have a 78 GMC K25 4x4 It's been sitting or 6 years. Went
Hi, I have a 78 GMC K25 4x4 It's been sitting for 5 or 6 years. Went to move it and the TH400 isn't engaging and going into gear. Ran fine the last time I drove it. The Trans fluid was very low (none … read more
Jared D
Jared D
Shop Supervisor
Bachelor's
2,386 satisfied customers
Hello, Our 1974 Dodge van B100 - 318cc engine, automatic
Hello, Our 1974 Dodge van B100 - 318cc engine, automatic transmission, The 318 is bored 40 thousands over with a mild cam and a Mallory ignition.I believe it will need a replacement transmission and t… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
I have a xj6 overdrive and want to fit it behind a 727 torkflite
I have a xj6 overdrive and want to fit it behind a 727 torkflite with a 354 blown hemi much like the Gear Vendors conversion ! my motor is probably in the 500h.p. area.Any idea what h.p. these unis ca… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
Hey doc. I just removed a 360 from a 79 d150. I have fresh
Hey doc. I just removed a 360 from a 79 d150. I have fresh rebuilt 400 ready to drop in. I want performance exhaust headers but do not want purchase only to have them not fit. Can you please advise on… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
coronet 440: trans..torque..tires..i pulled the tranny up by the bolts
i have a68 coronet440 with an 318 727trans rebuilt i installed the trans drove it one block came back check the fluid level drove it again came back and then it wouldnt move . so i reved it up and it … read more
6v_man_in_12v_world
6v_man_in_12v_world
210 satisfied customers
Corvette: small cam, small 1500 stall converter..gears..acceleration
I have a 1974, 454, Corvette, Turbo 400, 10-1 pistons, small cam, small 1500 stall converter. I want to change the rear end gears and am on the fence between 370 and 411. I seldom drive on the freeway… read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,034 satisfied customers
Chrysler Dodge I have a 3 speed torqueflite (cast iron) from
I have a 3 speed torqueflite (cast iron) from a '59 Dodge Custom Royal. Shifts properly into reverse, however takes forever to kick in to any forward gear. I have had several folks advise, get everyth… read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,034 satisfied customers
GM: turbo..Trans..the truck in gear and it will move both directions
GM turbo 400 Trans. Sometimes I can put the truck in gear and it will move both directions, lately it does not want to move at all.… read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,034 satisfied customers
stroker upgrade,big cam etc.,10.8 comp etc...tranny
How much pain can a fresh 727 built to standard specks be expected to handle behind a stout 440 in a Cuda. Open ended question i know,but i imported a Restored Cuda,new everything,however the new 440 … read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
Converter..neutral for a few seconds before the trans will shift..seal
I have a 1967 plymouth satellite that has a 727 trans. If the vehicle sits for any length of time the fluid drains down from the converter and I have to shift into neutral for a few seconds before the… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
Chrysler challenger Hi,i have a dodge challenger 73 E body.i
Hi,i have a dodge challenger 73 E body.i have replaced the old standard 440 magnum with a 440 stroked to 528 max wedge big block,750 HP-640 fpt.I was told the 3 speed slapstick 727 torqueflite could h… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
71 plymouth Scamp..360 rebuilt and it will have 325 hp
I have a 71 Plymouth Scamp with an original 225 slant 6 and original transmission. (A 904 three speed I believe). I am having a 360 rebuilt and it will have 325 HP and I want to know if I can use that… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
1971 Chrysler Newport: transmission valve body question...small block
I have a transmission valve body question. A few years ago I bought an engine and transmission out of a 1971 Chrysler Newport. The engine is a small block 360 and the transmission is an A-727. I bough… read more
Dale Stockstill
Dale Stockstill
Retired
Vocational, Technical or Trade Scho
1,034 satisfied customers
1978 dodge truck: auto trans, just put a new carb..accelerator..rpm
Hi, I have a 1978 dodge truck with a 225 slant 6, auto trans, just put a new carb on it. I notice if i push the accelerator down far enough to make it backshift too second gear, It doesnt have any pow… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
880 satisfied customers
Figuring..my 1979 Plymouth Volare...I know it..torque converter
I am having trouble figuring out which transmission is in my 1979 Plymouth Volare...I know it is a heavy duty transmission with a lock-up torque converter. I'm looking for the actual transmission iden… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
880 satisfied customers
F100: drives..high revs..vacuum hoses..it still wont change gear
my f100 wont change gear but drives in 1st and 2nd fine it used to only change at high revs but now not at all... i checked the vacuum hoses and ones was broken so i replaced it but it still wont chan… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
880 satisfied customers
What standard transmission with overdrive will fit behind ...
What standard transmission with overdrive will fit behind my ''76 FE 360 in my ''76 F-100 4x4 shortbed? also a 2sp transfer case?… read more
classictech
classictech
Consultant
Vocational, Technical or Trade Scho
108 satisfied customers
Buick: interior..tranny..the bolts that hold the torque converter
I recently purchased a ''55 Buick two door hardtop, jet black, rust free body, original interior, 266 nailhead, dyna flow, everything stock except for the dual exhausts that I just had installed. The … read more
Don - Mo Lurch
Don - Mo Lurch
Classic Car Mechanic
Vocational, Technical or Trade Scho
957 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Dr. Hamman

Dr. Hamman

Technician

2,436 satisfied customers

I have 30 years experience repairing, restoring, and customizing cars, and pickup trucks.

Don - Mo Lurch

Don - Mo Lurch

Classic Car Mechanic

957 satisfied customers

Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.

Don

Don

Classic Car Mechanic

951 satisfied customers

30 years of experience and we have 4 classic cars our selfs

Mike S.

Mike S.

Classic Car Mechanic

880 satisfied customers

A.S.E. certified with 25+ years experience.

K. Wiggins

K. Wiggins

Classic Car Mechanic

431 satisfied customers

ASE Certified Technician, Associates Degree in Automotive Technology, 15+ years in the trade

Dave Nova

Dave Nova

ASE Technician

415 satisfied customers

ASE Master Certification. GM World Class Certification

Road Side Jerry

Road Side Jerry

Auto Mechanic

280 satisfied customers

classic car mechanic

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x