How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mike S. Your Own Question
Mike S.
Mike S., Classic Car Mechanic
Category: Classic Car
Satisfied Customers: 7568
Experience:  A.S.E. certified with 25+ years experience.
Type Your Classic Car Question Here...
Mike S. is online now
A new question is answered every 9 seconds

Need wiring schematic Chevy Stylemaster with factory turn

Customer Question

Need wiring schematic for 1948 Chevy Stylemaster with factory turn signals. Has the factory wire harness, original electric 6 volt system.
Problem: Signal starting blowing fuse when used for left hand signal. Right signal, no problem. Turn signal fused sepertate. All other lights, front parking, rear tail and brake work with this fuse out. Change flasher to new plug in vs screw to wire original. Problem remains. Tony K
Submitted: 2 years ago.
Category: Classic Car
Expert:  Mike S. replied 2 years ago.
Does that do it for you?
Customer: replied 2 years ago.
I have a electrical problem within the factory installed turn signal system on a 1948 Chevrolet 2dr Stylmaster with 6 volt system. Just started blowing fues on the system. Has work up until now. Requested a wiring schematic for that 1948 vehicle system with FACTORY turn signals. The problem is just IN that SYSTEM, all other lights, parking, tail lights and brake lights continue to work as they should. Schematic sent does NOT show any turn signal wiring. Tony K
Expert:  Mike S. replied 2 years ago.
Yeah, I didn't even look at them because I know that is all that is available but let me look at them anyhow.
Expert:  Mike S. replied 2 years ago.
I believe the problem here is they were not standard equipment just yet in 1948. Try newer years wiring.
Expert:  Mike S. replied 2 years ago.
Customer: replied 2 years ago.
The 1952 Schematic is not correct. What is happening. BOTH signals work properly when the engine is NOT running. As soon as engine is started and generator is putting out the right signals blow the fuse. Left side does NOT cause fuse to blow running or not. Tony K
Expert:  Mike S. replied 2 years ago.

I'll just opt out. I have no diagram.