Classic Car

Have classic car questions? Ask an Expert.

Ask an Expert,
Get an Answer ASAP!

Related Classic Car Questions
how do i dissassemble a 1964 chevelle steering column as i
how do i dissassemble a 1964 chevelle steering column as i need to put a new turn signsl cable in,the old one has been pulled out… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
14,655 satisfied customers
Plymouth Barracuda: Looking for installation instructions fo
Looking for installation instructions fo a Federal power steering unit on a Plymouth Cuda with a 340 engine.I currently have an incorrect pump--a TRW pump---will the pulley fit the Federal???------tha… read more
Mike S.
Mike S.
Classic Car Mechanic
Vocational, Technical or Trade Scho
880 satisfied customers
Pontiac Firebird Trans Am: Dave, I had a brand new motor put
Dave, I had a brand new motor put together, then run on a dyno. The motor was shipped to me, but because of "issues", it has sat, drained of oil, for approximately one month. What can I do prior to st… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,323 satisfied customers
I bought a 62 Parisienne It has a straight 6 in it .How do
I bought a 62 Parisienne It has a straight 6 in it .How do I find out what size motor it is ive got the VIN and Block #s vin# (NNN) NNN-NNNNnbsp; #on block is(NNN) NNN-NNNNnbsp;… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
i have a 1964 cadillac with a 429 from what i believe to be
i have a 1964 cadillac with a 429 from what i believe to be from a 66-67 cadillac. block casting number(NNN) NNN-NNNN There is a spacer on the block to bell housing where the starter is mounted..the b… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
If I drive the truck daily it hardly drips from the front seal.
I have a 1973 C6 behind a 360. Before I installed it I replaced both the front and rear seal. If I drive the truck daily it hardly drips from the front seal. After is sits for a few days the fluid wil… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
1966 Ford: Neutral safety switch..seen were on the trans
Hello, Can you tell me where the 1966 Ford T'Bird Neutral safety switch is located and what is needed to adjust it? It is a C6 transmission, all C6 switches I have seen were on the trans itself. Thank… read more
Don - Mo Lurch
Don - Mo Lurch
Classic Car Mechanic
Vocational, Technical or Trade Scho
957 satisfied customers
Chrysler challenger Hi,i have a dodge challenger 73 E body.i
Hi,i have a dodge challenger 73 E body.i have replaced the old standard 440 magnum with a 440 stroked to 528 max wedge big block,750 HP-640 fpt.I was told the 3 speed slapstick 727 torqueflite could h… read more
Dr. Hamman
Dr. Hamman
Technician
Vocational, Technical or Trade Scho
2,436 satisfied customers
1972 monte carlo: trans..- rarely driven cruise nites etc..fluid leak
1972 monte carlo th 400 trans. restored - rarely driven cruise nites etc. i have owned it for 26 yrs. long ago it started with a small fluid leak then progressed. i changed the fluid new filter and a … read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
Chev..driven..parked..time, trans fluid begins to leak on to the floor
1955 chev cameo carrier. if driven weekly or so, no problem. but if parked for an extended period of time, trans fluid begins to leak on to the floor. after sitting for a coupla months upon starting i… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
1972 ford mustang mach 1: rebuilt..flow..transmission fluid..reverse
1972 ford mustang mach 1 with 1978 fmx transmission . Had it rebuilt but shop installed the incorrect filter (for 1972 fmx) thus blocking the flow of transmission fluid into pump. Transmission now lag… read more
Joe  Barfield
Joe Barfield
Retired-Disabled
Master Aamco
1,303 satisfied customers
I have a 57 chev with a differential casting # of 3726899.
I have a 57 chev with a differential casting # XXXXX(NNN) NNN-NNNN Can you tell me what it is?… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
Block casting is 3963512 but I need help with the date and other parts
I am looking for some engine i.D help. It is(NNN) NNN-NNNN69 or a(NNN) NNN-NNNN-71. block casting is(NNN) NNN-NNNNbut I need help with the date and other parts. I was told it is a COPO, motor but I ha… read more
Don
Don
Classic Car Mechanic
Vocational, Technical or Trade Scho
951 satisfied customers
small block..didnt check..bolt holes, which I took for LT1 heads
I have a small block 350, I was told it came out of a 1969 vette, I didn't check the casting numbers before I bought it due to it having double hump heads with bolt holes, which I took for LT1 heads, … read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
66 Chevelle Malibu: the Cowell plate..Intake Manifold..GM..Carb..Trans
On the Cowell plate on 66 Chevelle Malibu 2Dr Hartop, it says the following: Body 3F 5379 Paint FF 26541 ACC 26541 TR763 Engine Block ends in DJ Intake Manifold(NNN) NNN-NNNN GM NO21 Carb. 2JET Roches… read more
Kingman Kid
Kingman Kid
High School or GED
8 satisfied customers
Chevy: 1955, original engine and tranny..intake..exhaust..camshaft
ok guys show me your stuff; 6 cylinder chevy, 235ci, 2speed powerglide tranny, 1955, original engine and tranny... I am install offy intake with 2 single barrel carbs polish and porting the head insta… read more
Don
Don
Classic Car Mechanic
Vocational, Technical or Trade Scho
951 satisfied customers
1950 ford: real good..f..motor so im told, two barrel carb...rearend
hi , I've written before but the info got deleted so here it goes again and I really need some real good answers and pictures if possible: 1950 Ford F1 w/ a 1978 Pontiac 350 cu.in. motor so I'm told, … read more
Rick Armour
Rick Armour
Car Restorer
Vocational, Technical or Trade Scho
286 satisfied customers
Plymouth..Sport..I found it in a garage with only 31K on the clock
How do I know what engine is in a totally unmolested 1964 Plymouth Sport Fury? I found it in a garage with only 31K on the clock. It hasn't been registered since 1973. It has a 4 under the A on the bu… read more
Rick Armour
Rick Armour
Car Restorer
Vocational, Technical or Trade Scho
286 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Dr. Hamman

Dr. Hamman

Technician

2,436 satisfied customers

I have 30 years experience repairing, restoring, and customizing cars, and pickup trucks.

Don - Mo Lurch

Don - Mo Lurch

Classic Car Mechanic

957 satisfied customers

Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.

Don

Don

Classic Car Mechanic

951 satisfied customers

30 years of experience and we have 4 classic cars our selfs

Mike S.

Mike S.

Classic Car Mechanic

880 satisfied customers

A.S.E. certified with 25+ years experience.

K. Wiggins

K. Wiggins

Classic Car Mechanic

431 satisfied customers

ASE Certified Technician, Associates Degree in Automotive Technology, 15+ years in the trade

Dave Nova

Dave Nova

ASE Technician

415 satisfied customers

ASE Master Certification. GM World Class Certification

Road Side Jerry

Road Side Jerry

Auto Mechanic

280 satisfied customers

classic car mechanic

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x