Chrysler

Chrysler repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chrysler Questions
Cannot accelarate wont go over 20 miles idle high and red
cannot accelarate wont go over 20 miles idle high and red lighting bolt light on and doesn't have my manual book to see this … read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
I am trying to change the ckp sensor however i have found a
i am trying to change the ckp sensor however i have found a few that look like the new i want to be sure i am replacing the right one where should it be located … read more
K. Wiggins
K. Wiggins
ASE Certified Technician
Associate Degree
3,969 satisfied customers
Car idles rough and loses power when you apply throttle.
Car idles rough and loses power when you apply throttle … read more
Matt C.
Matt C.
ASE certified Master Technician
Certificate of Completion
56 satisfied customers
I have chrysler grand voyager (2008) diesel 2.8. OBDII
Hi! I have chrysler grand voyager (2008) diesel 2.8. OBDII scanner gives error code P252F (engine oil level is too high). On dashboard I see "oil change required" signal after starting engine and "che… read more
Don - Mo Lurch
Don - Mo Lurch
Aftermarket & Factory Electronics
Vocational, Technical or Trade Scho
578 satisfied customers
I have a 2012 Chrysler 200 with the 2.4 and it just started
I have a 2012 Chrysler 200 with the 2.4 and it just started to stall while driving.Has no codes.I was reading that I might have to change the oil I have never heard of this before.… read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
I have a 2011 Chrysler 200 limited convertible and the
I have a 2011 Chrysler 200 limited convertible and the electric throttle control lighting bolt light came on and the car just cranked over and would not start. The key stayed stuck in the start positi… read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
How can I determine which knock sensor is in a 2004 Chrysler
How can I determine which knock sensor is in a 2004 Chrysler Sebring 2.7. It shows 2 types were used.… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,507 satisfied customers
chrysler sebring: Tim. I have a 97 chrysler sebring conv.
Tim. I have a 97 chrysler sebring conv. The scanner shows a OL status at startup then shortly an OL fault and goes in CL closed loop within seconds after cold start and can't figure out what's wrong. … read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
pt cruiser: overheating..timing belt..broke the cool temp sending unit
my ptcruiser 2002 shows obdii code po118 and when running the dash light indicates its overheating but the temperature guage never moves off cold. also I changed the timing belt yesterday. broke the c… read more
Mopar Certified
Mopar Certified
Vocational, Technical or Trade Scho
12,121 satisfied customers
2004 PT Cruiser: manual transmission..intermittent..rpms..idles
I have 2004 PT Cruiser that stalls when I decelerate. It has a manual transmission, and when it stalls the engine just dies but all of the electrical still works i.e radio, lights, etc. This issue is … read more
Stonyman
Stonyman
automotive technician
High School or GED
723 satisfied customers
Pt cruiser: camshaft..crankshaft sensor..a code of P0344 and P0334
Have a 03 pt cruiser turbo.. I recently wrote about a camshaft and crankshaft sensor problem. Have a code of P0344 and P0334. I replaced them both and now get this list: 0 codes Mil off Monitors 3 Inc… read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
1997 Chrysler Cirrus: rotor..compression..cylinders..MAP sensor
1997 Chrysler Cirrus - 2.5 v6 Hard starting, then when running stumbles on acceleration changed throttle position sensor, new plugs, new wires, new distributor cap and rotor, changed fuel filter, new … read more
Amedee
Amedee
Chrysler Technician
Vocational, Technical or Trade Scho
1,081 satisfied customers
1993 Chrysler Concorde: throttle body,cam sensor..egr valve..solenoid
1993 Chrysler Concorde,3.3L Automatic: Problem starting cold or hot continues to turn over, turn key on and off several times and then it will start but sounds like it is flooding itself out.Have 2 pr… read more
Doug In North Carolina
Doug In North Carolina
Automotive Service Technician
Vocational, Technical or Trade Scho
301 satisfied customers
1999 chrysler concorde: the check engine light comes..car dies..30 min
i have a 1999 chrysler concorde.while driving the check engine light comes on and the car dies,but starts right back up.sometimes it does it two or three times 30 min after first starting it and some … read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
1999 Chrysler Sebring: will stall..freeway..third gear..rebuilt
My 1999 Chrysler Sebring JXi will stall at stops and sometimes while driving on the freeway on slight inclines. Any ideas? It also makes a large clunking sound when going between second and third gear… read more
Stonyman
Stonyman
automotive technician
High School or GED
723 satisfied customers
I just purchased a 2004 PT Cruiser (non-turbo) that seems to
I just purchased a 2004 PT Cruiser (non-turbo) that seems to be in great shape. It has 65,000 miles on it and it looks and drives like new except for one problem. When the car is started first thing i… read more
Chris
Chris
16,636 satisfied customers
99 chrysler 300m: 000 miles..restart..shake..my foot on the gas pedal
my 99 chrysler 300m has 169,000 miles. For a few years now it has a recurring problem that shows its ugly head every few months. It shuts off when it starts and then I restart it and it starts to shak… read more
John
John
Vocational, Technical or Trade Scho
2,235 satisfied customers
2000 chrysler sebring: 197,000 miles..gas pedal..tuned..same problem
My 2000 Chrysler Sebrinb Convertible with 197,000 miles on it starts only with some gas pedal help. It won't idle on its own until after about 3 or 4 miles of driving at which point it is good. Just t… read more
sprinkles08
sprinkles08
Technician
High School or GED
19,127 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

I AM VERY GLAD THAT I TOOK A CHANCE ON YOUR PROBLEM SOLVING SKILLS. I WAS SUCCESSFUL IN REPLACING THE FUEL PUMP. MY TRUCK RUNS LIKE A CLOCK. IT RUNS LIKE THE DAY I BOUGHT IT. NO LUNGING FORWARD, THE TURBO REACTS THE SECOND I STOMP ON THE GAS, AND IT HAS A LOT MORE POWER AND EVEN SOUNDS BETTER TO ME. IT SAVED ABOUT $500.00 BY DOING THE WORK MYSELF. I GIVE YOU ALL THE CREDIT FOR YOUR DIAGNOSING THE PROBLEM, JUST FROM THE SYMPTONS I GAVE YOU OVER THE e MAIL. I WILL USE YOUR WEB SITE AGAIN AND REFER MY FRIENDS. THANKS SO MUCH FOR THE HELP.

TOM WHITTAKERUSA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

Rev. Jerry BaysingerHolts Summit, Mo

I recently asked a question about my 2005 dodge ram, and I just wanted to let my Expert know that he hit the nail squarely on the head with his answer. I wanted to thank him again.

GregPittsburgh, PA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

JerryHolts Summit, MO

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Don - Mo Lurch

Don - Mo Lurch

Aftermarket & Factory Electronics

578 satisfied customers

Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years

Chris (aka - Moose)

Chris (aka - Moose)

Technician

729 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

121 satisfied customers

ASE Master Tech 20+ Years

Ivan

Ivan

ASE Certified Master Technician

56 satisfied customers

ASE Master Tech w/ 20+ years in the field. Self employed for 9 years. Member of AUTOLAB radio show.

garrtim

garrtim

service manager

1,116 satisfied customers

20+ years chrysler certified

Amedee

Amedee

Chrysler Technician

1,081 satisfied customers

ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

697 satisfied customers

ASE Master tech. 30+ years mechanic, shop forman, service manager

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x