Chrysler

Chrysler repair questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Chrysler Questions
Chrysler Concorde LXi: 2000 Concorde 3.2 engine logging cam
2000 Concorde 3.2 engine logging cam sensor codes. Most of the time when it acts up is after you come back to the car after coming out of the store or where ever you cut it off after driving. Not all … read more
sprinkles08
sprinkles08
ASE Certified Technician
High School or GED
24,353 satisfied customers
Chrysler Concorde LXi: 03 concorde lxi, 3.5 liter, 125k with
'03 concorde lxi, 3.5 liter, 125k with original timing belt, intermittent warm start failure, cranks but won't start. P 0340 code and replaced cam shaft sensor. pulling and replacing "new" fuel pump r… read more
sprinkles08
sprinkles08
ASE Certified Technician
High School or GED
24,353 satisfied customers
Chrysler Concorde: I have a 1997 chrysler concord lx 3.5 v6
I have a 1997 chrysler concord lx 3.5 v6 and all I did was change the battery and the alarm started going off I do not have the remote for it the owners manual says to put the key in either front door… read more
sprinkles08
sprinkles08
ASE Certified Technician
High School or GED
24,353 satisfied customers
I have a 04 concord with no spark I have changed the crank
I have a 04 concord with no spark I have changed the crank sensor and cam sensor, and then after all of that had the body computer changed and flashed at the dealer it worked for a day or so now again… read more
TIM MOHR
TIM MOHR
SHOP OWNER
Master's Degree
8,037 satisfied customers
Chrysler town and country: i have a 1997 chrysler town and
i have a 1997 chrysler town and country and it wont start it was showing a cam sencer code and so i changed the cam sencer and it started a couple times then it did the same thing again so i changed t… read more
Expert
Expert
31 satisfied customers
2000 Chrysler 300m: cyl..check engine..auto parts..rigth bank to rich
2000 Chrysler 300m 3.5 engine, the car start & run but on three cyl. check engine on took it to advence auto parts code 172 the rigth bank to rich.… read more
jeepmopar76
jeepmopar76
Master tech
Vocational, Technical or Trade Sc
4 satisfied customers
2001 concord 3.2 eng. eng stopped out on the highway.
2001 concord 3.2 eng. eng stopped out on the highway. now won't start. replaced fuel pump and crank sensor. Tested crank sensor harness and had 9 volts, chiltens manual said it should be 5 volts. have… read more
sprinkles08
sprinkles08
ASE Certified Technician
High School or GED
24,353 satisfied customers
1995 Chrysler Intrepid: Camshaft position sensor but no luck..plate
1995 Chrysler Intrepid no spark no fuel on plug - replaced the Camshaft position sensor but no luck. Is the gap between sensor and drive plate crucial… read more
sprinkles08
sprinkles08
ASE Certified Technician
High School or GED
24,353 satisfied customers
1995 Concorde: It shows spark but I did change the ignition coil
1995 Concorde turns over but no start. It shows spark but I did change the ignition coil and it did nothing. ( returned to part store). Change PCM and still no start ( retuned to part store) I show 8 … read more
Amedee
Amedee
Chrysler Technician
Vocational, Technical or Trade Scho
956 satisfied customers
2000 LHS: I asked a similar question before...Would..cam..sensors
I asked a similar question before...Would a 3.5 high output engine from a 2000 LHS work in a 2002 Concorde that has a regular 3.5 in it already? If so is there anything else that has to be changed bes… read more
rich
rich
Associate Degree
212 satisfied customers
95 chrysler concorde: cam sensor..crank sensor..throttle body..towed
95 chrysler concorde 3.3 t code found broken cam sensor wire repaired and replaced cam and crank sensor acording to on off on procedure codes car runs fine for two days then starts to run on 2 cylinde… read more
John
John
Vocational, Technical or Trade Scho
1,209 satisfied customers
97 concord: crank sensor..p1391 Intermittent Loss of cmp..ckp code
I have a 97 concord that has had a recent computer and crank sensor put in ( last week ) today its giving me a p1391 Intermittent Loss of CMP or CKP code could anyone please tell me what to do to corr… read more
Mopar_Certified
Mopar_Certified
Vocational, Technical or Trade Scho
5 satisfied customers
2002 Concorde LXI: with 3.5 liter, runs normal and smooth..rpm..rev
My 2002 Concorde LXI with 3.5 liter, runs normal and smooth till it reaches 2200 rpm. Then it shuts down like a rev limiter kicking in. It makes no differance what the speed is. Doesn't matter if it's… read more
Mopar_Certified
Mopar_Certified
Vocational, Technical or Trade Scho
5 satisfied customers
1995 chrysler concorde: acts..it is misfiring/surging..highway speeds
1995 chrysler concorde 3.5 engine. Runs OK when cold. When engine is up to operating temperature the engine acts like it is misfiring/surging from just above idle to city and highway speeds. It does i… read more
mopar money
mopar money
Vocational, Technical or Trade Scho
172 satisfied customers
2002 chrysler concorde lx: accelerate..alternator..check engine light
I have a 2002 chyrsler concorde lx. the car over heated 2 weeks ago and coolant reservoir was replaced and sparks plugs changed. While driving on highway a few days ago, car stuttered a little then do… read more
John
John
Vocational, Technical or Trade Scho
1,209 satisfied customers
95 concorde: an extended crank..stall..fuel pump..injector
my 95 conorde has an extended crank when cold and sometimes when driving t will stumble and stall or just stumble ive gone from front to back strting with the fuel pump the pressure regulator then inj… read more
John
John
Vocational, Technical or Trade Scho
1,209 satisfied customers
Chrysler cirrus: cap..rotor, oil change, air filter
my chrsyler cirrus is a 96, 6 cylinder and when i take off it bogs down real bad until i hit about 25 mph and then it drives fine.I have changed plugs distributer cap, and rotor, oil change, air filte… read more
John
John
Vocational, Technical or Trade Scho
1,209 satisfied customers
1995 Chrysler Concorde: Cam shaft sensor..voltage..cranking..signal
Cam shaft sensor on a 1995 Chrysler Concorde has reference voltage but no cranking signal. Cam shaft gear appears to be OK. The car will not start. What could be the problem?… read more
Mopar_Certified
Mopar_Certified
Vocational, Technical or Trade Scho
5 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

I AM VERY GLAD THAT I TOOK A CHANCE ON YOUR PROBLEM SOLVING SKILLS. I WAS SUCCESSFUL IN REPLACING THE FUEL PUMP. MY TRUCK RUNS LIKE A CLOCK. IT RUNS LIKE THE DAY I BOUGHT IT. NO LUNGING FORWARD, THE TURBO REACTS THE SECOND I STOMP ON THE GAS, AND IT HAS A LOT MORE POWER AND EVEN SOUNDS BETTER TO ME. IT SAVED ABOUT $500.00 BY DOING THE WORK MYSELF. I GIVE YOU ALL THE CREDIT FOR YOUR DIAGNOSING THE PROBLEM, JUST FROM THE SYMPTONS I GAVE YOU OVER THE e MAIL. I WILL USE YOUR WEB SITE AGAIN AND REFER MY FRIENDS. THANKS SO MUCH FOR THE HELP.

TOM WHITTAKERUSA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

Rev. Jerry BaysingerHolts Summit, Mo

I recently asked a question about my 2005 dodge ram, and I just wanted to let my Expert know that he hit the nail squarely on the head with his answer. I wanted to thank him again.

GregPittsburgh, PA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

JerryHolts Summit, MO

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Don - Mo Lurch

Don - Mo Lurch

Aftermarket & Factory Electronics

545 satisfied customers

Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years

Chris (aka - Moose)

Chris (aka - Moose)

Technician

568 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

118 satisfied customers

ASE Master Tech 20+ Years

Ivan

Ivan

ASE Certified Master Technician

56 satisfied customers

ASE Master Tech w/ 20+ years in the field. Self employed for 9 years. Member of AUTOLAB radio show.

Amedee

Amedee

Chrysler Technician

956 satisfied customers

ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

696 satisfied customers

ASE Master tech. 30+ years mechanic, shop forman, service manager

Ron

Ron

ASE Certified Technician

419 satisfied customers

#@ years in the Automotive repair field.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x