How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask K. Wiggins Your Own Question
K. Wiggins
K. Wiggins, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 2956
Experience:  ASE Certified Technician, Associates Degree in Automotive Technology, 15+ years in the trade
68360881
Type Your Chrysler Question Here...
K. Wiggins is online now
A new question is answered every 9 seconds

Sputtering, back fire, loss of power, check engine light

Customer Question

sputtering, back fire, loss of power, check engine light constantly on, and sometimes blinking, and when the engine stalls at a complete stop, the throttle body control light on the dash also comes on. Changed all O2 sensors, MAP sensor, but the P0660 code will not go away. I think we have narrowed the problem to the manifold tuning valve, but I'm not convinced.
JA: Does the light stay on, or does it blink?
Customer: check engine does both.
JA: What is the model/year of your Chrysler?
Customer: 2006 chrysler 300 base model 2.7l
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: yes.
JA: Anything else you think the mechanic should know?
Customer: as stated above, we've changed all o2 sensors, MAP sensor, and spark plugs
Submitted: 1 year ago.
Category: Chrysler
Expert:  K. Wiggins replied 1 year ago.

Hello, this is indeed an issue with the MTV or operating circuit. I'll post troubleshooting info below. If I can help further just reply back.

Customer: replied 1 year ago.
Ok, I found the piece and replaced it. Do I need to reset the computer or anything for it to act right again?
Expert:  K. Wiggins replied 1 year ago.

You'll need to clear the codes with a scan tool

Customer: replied 1 year ago.
Did that. Still the same issue.
Customer: replied 1 year ago.
Any other suggestions?
Expert:  K. Wiggins replied 1 year ago.

You'll need to go through the troublechart I sent and check the wiring for opens/shorts. IF wiring passes it's going to be an ECM issue

Customer: replied 1 year ago.
I replaced the wire when I replaced the mtv
Customer: replied 1 year ago.
ECM means?
Expert:  K. Wiggins replied 1 year ago.

Engine control module

Customer: replied 1 year ago.
The computer?
Customer: replied 1 year ago.
Will having it flashed help or will I need to replace it?
Expert:  K. Wiggins replied 1 year ago.

It'll need to be replaced and the new one flashed.