Chrysler

Chrysler repair questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

I have a 2012 Chrysler Town & Country -L with 75,000 miles…

Customer Question
I have a 2012 Chrysler...
I have a 2012 Chrysler Town & Country -L with 75,000 miles on it and over the past year my the engine service light has gone out then comes on several months later. I don't notice any difference in the engine performance though. Should I replace the o2 sensors or when do go bad is it off and then on with o2 sensors?
Thanks,
David
Submitted: 2 years ago.Category: Chrysler
Show More
Show Less
Ask Your Own Chrysler Question
Answered in 41 minutes by:
2/21/2016
Chrysler Mechanic: roybelding, ASE Certified Technician replied 2 years ago
roybelding
roybelding, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 7,581
Experience: Extensive experience working with all models of Chrysler for over 35 years
Verified

good evening my name is ***** ***** I will assist

we need the code to accurately help you. the codes are stored in memory and can be retrieved.

an evap code will set occasionally if you do not tighten your gas cap all the way. it will not effect your engine performance. this is a guess but can confirm with the code.

do not replace anything unless you confirm a failure. guesses are mostly wrong and get expensive

Roy

Ask Your Own Chrysler Question
Was this answer helpful?
Ask roybelding Your Own Question
roybelding
roybelding
roybelding, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 7,581
7,581 Satisfied Customers
Experience: Extensive experience working with all models of Chrysler for over 35 years

roybelding is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

I AM VERY GLAD THAT I TOOK A CHANCE ON YOUR PROBLEM SOLVING SKILLS. I WAS SUCCESSFUL IN REPLACING THE FUEL PUMP. MY TRUCK RUNS LIKE A CLOCK. IT RUNS LIKE THE DAY I BOUGHT IT. NO LUNGING FORWARD, THE TURBO REACTS THE SECOND I STOMP ON THE GAS, AND IT HAS A LOT MORE POWER AND EVEN SOUNDS BETTER TO ME. IT SAVED ABOUT $500.00 BY DOING THE WORK MYSELF. I GIVE YOU ALL THE CREDIT FOR YOUR DIAGNOSING THE PROBLEM, JUST FROM THE SYMPTONS I GAVE YOU OVER THE e MAIL. I WILL USE YOUR WEB SITE AGAIN AND REFER MY FRIENDS. THANKS SO MUCH FOR THE HELP.

TOM WHITTAKERUSA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

Rev. Jerry BaysingerHolts Summit, Mo

I recently asked a question about my 2005 dodge ram, and I just wanted to let my Expert know that he hit the nail squarely on the head with his answer. I wanted to thank him again.

GregPittsburgh, PA

Just a quick line to tell you how pleased I am to have my brakes working properly after all this time. Your answer was what I needed. I would certainly recommend you highly. God bless!

JerryHolts Summit, MO

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Don - Mo Lurch

Don - Mo Lurch

Aftermarket & Factory Electronics

527 satisfied customers

Cert. Chrysler Warnty, Heavy Line Mech, Mobile Electronics. Sales, Installation & Repair for 30 years

Chris (aka - Moose)

Chris (aka - Moose)

Technician

483 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

118 satisfied customers

ASE Master Tech 20+ Years

Ivan

Ivan

ASE Certified Master Technician

56 satisfied customers

ASE Master Tech w/ 20+ years in the field. Self employed for 9 years. Member of AUTOLAB radio show.

Amedee

Amedee

Chrysler Technician

899 satisfied customers

ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

696 satisfied customers

ASE Master tech. 30+ years mechanic, shop forman, service manager

Ron

Ron

ASE Certified Technician

373 satisfied customers

#@ years in the Automotive repair field.

< Previous | Next >

Related Chrysler Questions
P0420 MIL code on Chrysler 2005 Town and Country
Got a P0420 MIL CODE. Chrysler 2005 Town and Country 3.8L. Brief History: Between 100-150K miles. Fairly good maintenance. Recently replaced EGR valve for second time (just proactive for mileage etc.)… read more
proautotech
proautotech
Shop Foreman
1,144 satisfied customers
I have a p2096 engine code on a 2011 town and country with
I have a p2096 engine code on a 2011 town and country with 3.6 engine where do I start. I got the code once before and reset it. Now it is back again. There are about 75000 miles on it. Will spark plu… read more
bill
bill
chrysler dodge jeep tech
Vocational, Technical or Trade Scho
458 satisfied customers
2000 chrysler: engine fuse keeps blowing..start my
The engine fuse keeps blowing when I try to start my 2000 chrysler town and country… read more
Mopar_Certified
Mopar_Certified
Vocational, Technical or Trade Scho
5 satisfied customers
It is overheating after I have replaced the O2 sensor,
It is overheating after I have replaced the O2 sensor, thermostat, radiator, water pump, timing belt, throttle body. … read more
jc_davil
jc_davil
41 satisfied customers
The o2 sensor was disconnected and it has a ticking noise
the o2 sensor was disconnected and it has a ticking noise now … read more
Dan
Dan
Dealership Technician
Associate Degree
2,056 satisfied customers
I had a o2 sensor bank 1 sensor 1 so i changed the upstream
I had a o2 sensor bank 1 sensor 1 so i changed the upstream o2 sensor and now i have a p0171 code saying system too lean bank 1 … read more
baddad1
baddad1
technician
High School or GED
5 satisfied customers
04 Intrepid 2.7 L o2 sensor high voltage 2.49 V, they are
04 Intrepid 2.7 L o2 sensor high voltage 2.49 V , they are all brand new ...What is causing the excessive volts ...suppose to be 0,4 to 0.9 V … read more
Pete
Pete
Mechanic
Construction, Plant Fitter
136 satisfied customers
2 downstream O2 sensors replaced and still check engine
2 downstream O2 sensors replaced and still check engine light is on. 2008 Chrysler Sebring Convertible … read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
373 satisfied customers
P0134 error and its not the O2 sensor. Only the upstream.
Only the upstream. Just had it replaced 30 minutes ago and warning light came on as I left driveway. … read more
Matt
Matt
Engineer
Bachelor\u0027s Degree
5 satisfied customers
Had a new o2 sensor put on but check engine light is still
Had a new o2 sensor put on but check engine light is still on … read more
roybelding
roybelding
ASE Certified Technician
7,581 satisfied customers
Same p1034 code on after two year and 5 o2 sensors. Unknown.
Same p1034 code on after two year and 5 o2 sensors. … read more
roybelding
roybelding
ASE Certified Technician
7,581 satisfied customers
Received code P0135. Bank 1 sensor 1, o2 sensor for a 2006
o2 sensor for a 2006 Chrysler Pacifica 3.5 L MPI 24-valve V6 engine … read more
Eric
Eric
Auto Technician
589 satisfied customers
Chrysler 300C AWD Problem only on cold start up. After sitting
Problem only on cold start up. After sitting for more than 12 hours the car starts and rpms are at 11-1200. As the rpms drop to normal the engine shakes and engine light goes on. I can only keep it ru… read more
Dr.Automotive
Dr.Automotive
Associate Degree
62 satisfied customers
1997 Plymouth Breeze 2.0L. Crank no start.
1997 Plymouth Breeze 2.0L. Crank no start. Fuel pressure is 45 psi. There is good spark and injector pulse. Have checked cam timing and it is correct. Compression is approx 125 for all cylinders. Repl… read more
Expert
Expert
30 satisfied customers
98 chrysler cirrus: runs great..stalls..crank cam and dist all line
my 98 chrysler cirrus runs great at start up once it reaches 206 degress it starts to run rough missing and stalls out. it starts back up and runs like it missing on 2cylinders and pops back through t… read more
Expert
Expert
30 satisfied customers
code reads p0032 heater cicuit high voltage
code reads p0032 heater cicuit high voltage… read more
Stonyman
Stonyman
automotive technician
High School or GED
307 satisfied customers
My car or sitting at a stoplight idling..jerks..accelerates
After starting my car or sitting at a stoplight idling, my car losses power when I hit the gas and jerks and abruptly accelerates. What could be causing this problem?… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
2004 Chrysler Town & Country: a 3.3L engine, where are the O2 sensors
On a 2004 Chrysler Town & Country with a 3.3L engine, where are the O2 sensors located?… read more
zzdaryl
zzdaryl
Lead Auto Tech
Some college and advanced training
4 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x