How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tool Hut Your Own Question
Tool Hut
Tool Hut, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 550
Experience:  Owner of a mobile diagnostics company assisting auto technicians with difficult vehicles
77480539
Type Your Chrysler Question Here...
Tool Hut is online now
A new question is answered every 9 seconds

Chrysler 300 C: I have 2012 chrysler 300c and I took it to

Customer Question

I have 2012 chrysler 300c and I took it to the agency many time complaining from vibration on the entire car after 70 miles. Some time there is no vibration and some time it goes and comes again especially while full acceleration. When I drive smothly there is no but it comes within a minutes
Submitted: 2 years ago.
Category: Chrysler
Expert:  Tool Hut replied 2 years ago.
How many miles do you have on your vehicle? I would suspect you have a bad motor mount. possibly a bad tire
Customer: replied 2 years ago.
It's 65000 km. tire are new prille brand p-zero and engine mount has been changed recently but still I have this issue
Expert:  Tool Hut replied 2 years ago.
When does the vibration occur? Under acceleration? Speed?
Customer: replied 2 years ago.
Both
Expert:  Tool Hut replied 2 years ago.
What speed is vibration worst? Can you do any driving maneuver to make it less?
Customer: replied 2 years ago.
It's starting from 90 and above. Sometime the vibration totally gone but most of time there is vibration
Expert:  Tool Hut replied 2 years ago.
Do you have aftermarket wheels? Did the vibration start with new tires?
Customer: replied 2 years ago.
I had the original rims and the vibration even before I changed the tires
Expert:  Tool Hut replied 2 years ago.
Are they aftermarket wheels?
Expert:  Tool Hut replied 2 years ago.
At those speeds I would suspect wheels or an axle shaft out of balance. Do you have access to a shop that can balance wheels on the car?
Expert:  Tool Hut replied 2 years ago.
Did you figure anything out?