How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 23117
Experience:  ASE Master & Advanced level certified, Chrysler Master Certified, Trans and Hybrid Specialist
Type Your Chrysler Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Chrysler Town & Country Touring: having trouble getting

Customer Question

having trouble getting the P codes to display on my 2005 Chrysler T&C. It turns over but will not start.
Submitted: 2 years ago.
Category: Chrysler
Expert:  sprinkles08 replied 2 years ago.
Hello and welcome to JustAnswer!
If the engine cranks but does not start then the most likely causes would be a lack of crank sensor signal or low/no fuel pressure. If it's a fuel pressure issue then there will be no codes set.
The key cycle method will work on this if done correctly. With the doors closed insert the key and turn it one click forward. This is off. One click forward of that is on. Start with it off and go on, off, on, off, on within about five seconds and any codes stored in the engine controller should appear in the odometer.
If that doesn't work then see if you're able to hear the fuel pump run when the key is first turned on. If not, check for spark. If spark is present then the next step would be checking the power and ground at the pump.