How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask ND-TECH Your Own Question
ND-TECH, CJDR Master Tech
Category: Chrysler
Satisfied Customers: 1410
Experience:  ASE Certified and CJDR Master
Type Your Chrysler Question Here...
ND-TECH is online now
A new question is answered every 9 seconds

How do I remove the starter in my 99 chrysler town and country 3.8?

Customer Question

how do I remove the starter in my 99 chrysler town and country 3.8?
Submitted: 6 years ago.
Category: Chrysler
Expert:  ND-TECH replied 6 years ago.


  1. Release hood latch and open hood.
  2. Disconnect and isolate the battery negative cable Battery Negative Cable
  3. Hoist and support vehicle on safety stands.
  4. Remove nut holding B+ terminal to starter solenoid Starter - 3.3 / 3.8L Engine Wire Connectors
  5. Disconnect solenoid connector from starter.
  6. Remove bolts holding starter to transaxle bellhousing Starter Bolts
  7. Remove starter from bellhousing Starter - 3.3/3.8L Engine
  8. Separate starter spacer from transaxle bellhousing.


  1. Place starter spacer in position on transaxle bellhousing, flange toward flywheel.
  2. Place starter in position on bellhousing.
  3. Install bolts to hold starter to transaxle bellhousing.
  4. Connect solenoid connector into starter.
  5. Install nut to hold B+ terminal to starter solenoid.
  6. Lower vehicle.
  7. Connect battery negative cable.
  8. Verify starter operation.