How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jerry Your Own Question
Jerry, Master Mechanic
Category: Chrysler
Satisfied Customers: 17220
Experience:  ASE Master tech. 30+ years mechanic, shop forman, service manager
Type Your Chrysler Question Here...
Jerry is online now
A new question is answered every 9 seconds

Replacing the power steering pump pulley on a Voyager

Customer Question

Replacing the power steering pump pulley on a Voyager
Submitted: 7 years ago.
Category: Chrysler
Expert:  Jerry replied 7 years ago.
Hello and welcome to Just, Super mechanic here. About your vehicle.

Power Steering Pump Pulley Replacement


  1. Remove the pulley from the shaft of the power steering pump using Puller C-4333 or C-4068, or equivalent. CAUTION: Do not hammer on power steering pump pulley. This will damage the pulley and the power steering pump.
  2. Replace pulley if it is found to be bent, cracked, or loose.


  1. Install the pulley with Installer C-4063, or equivalent. Do not use the tool adapters.
  2. Ensure that the tool and the pulley remain aligned with the pump shaft. Prevent the pulley from being cocked on the shaft.


  1. Force pulley flush with the end of the power steering rums shaft.
  2. With serpentine belts, run engine until warm (5 min.) and note any belt chirp. If chirp exists, move pulley outward approximately 0.5 mm (0.020 inch) . If noise increases, press on 1.0 mm (0.040 inch) . Be careful that pulley does not contact mounting bolts.

Related Chrysler Questions