How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask b5demon Your Own Question
b5demon
b5demon, ASE Certified Technician
Category: Chrysler
Satisfied Customers: 3726
Experience:  ASE and Chrysler master technician with over 17 years in dealer
13235514
Type Your Chrysler Question Here...
b5demon is online now
A new question is answered every 9 seconds

HOW TO REMOVE MOTOR MOUNT CROSS BAR ON 2000 SEBRING CONVER

Customer Question

HOW TO REMOVE MOTOR MOUNT CROSS BAR ON 2000 SEBRING CONVERT.
Submitted: 7 years ago.
Category: Chrysler
Expert:  brownjeff replied 7 years ago.
I'm sorry which one? Front, rear, left, right?
Customer: replied 7 years ago.
I NEED TO REMOVE THE BAR THAT RUNS UNDER THE OIL PAN THAT HOUSES FRONT AND REAR MOUNTS
Expert:  brownjeff replied 7 years ago.

Is this what your after?

 

REMOVAL
FRONT MOUNT

  1. Raise vehicle on hoist.



Fig. 30

  1. Remove through bolt (A) at front mount (Fig. 30).
  2. Remove attaching bolts from mount to lower radiator support crossmember. NOTE: It may be necessary to tilt engine for front mount removal clearance.
  3. Remove front mount.

REAR MOUNT

  1. Raise vehicle on hoist.



Fig. 31

  1. Remove through bolt (A) from rear engine mount and bracket (Fig. 31).



Fig. 29

  1. Remove rear strut bracket (Fig. 29).
  2. Remove bolts attaching rear mount to crossmember. NOTE: It may be necessary to tilt engine for rear mount removal clearance.
  3. Remove rear mount.

INSTALLATION
FRONT MOUNT

  1. Position front mount. Install front mount to lower radiator support crossmember attaching bolts. Tighten bolts to 61 Nm (45 ft. lbs.)
  2. Install through bolt (A) (Fig. 30).
  3. Tighten front through bolt (A) to 61 Nm (45 ft. lbs.) (Fig. 30).
  4. Lower vehicle.

REAR MOUNT

  1. Position rear mount.
  2. Install bolts attaching rear mount to suspension crossmember. Tighten bolts to 61 Nm (45 ft. lbs.).
  3. Install rear strut bracket (Fig. 29). Tighten bolts to 61 Nm (45 ft. lbs.) .
  4. Install through bolt (A) and tighten 61 Nm (45 ft. lbs.) (Fig. 31).
  5. Lower vehicle

 

Customer: replied 7 years ago.
the mounts I am working with are on a convertible. The front and rear mounts are connected with a bar that runs under the oil pan. I have removed everything and the bar is free EXCEPT the rear mount is hanging up between the Rack and pinion steering and the passenger side drive shaft(the long shaft). How do I get the motor mount past the these components
Expert:  brownjeff replied 7 years ago.
Let me see then if another expert can help as this is the information I have. Hang on one should be with you shortly.
Expert:  b5demon replied 7 years ago.
if you remove the passengers side axle shaft it usually gives you enough room to get it out but i have had to also loosen the rack bolts at times to get it out also