Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
I have a 6.5 chevy diesel with po216 and p1214 codes. runs
I have a 6.5 chevy diesel with po216 and p1214 codes. runs great till 170 then sputters and smokes.… read more
Scott
Scott
GM Master Technician
Bachelor's Degree
433 satisfied customers
I keep getting a PO107 code which according to my reader is
I keep getting a PO107 code which according to my reader is the MAP sensor. I have tried switching it out with another on off of a similar vehicle, but I still get the code. What can I do? Do I have t… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,420 satisfied customers
Chevrolet K3500 4x4: 96 K3500 7.4L P0102 sets during KOEO test
96 K3500 7.4L P0102 sets during KOEO test only. Code will not set if engine is running. B+ voltage good, ground good, signal from computer 5v.… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,931 satisfied customers
I have a 04 Monte Carlo ss 3.8 Super charged.15 seconds or
I have a 04 Monte Carlo ss 3.8 Super charged.15 seconds or so after start up, the engine "LOPES" then dies. Starts right back up but after about 15 sec it does it again. Replaced MAF and cleaned the I… read more
Roy Belding
Roy Belding
7,663 satisfied customers
94 3.4: egr was bad..vaccum leaks..pcm replaced..few miles
I have a 94 3.4 caramo thats runs rough/ very rich, head gskets were just done, egr was bad and replaces, both o2s were replaced as they were broken off, vaccum leaks were found and fixed, pcm replace… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
23,044 satisfied customers
1994 k1500 350 tbi..rough idle..gear runs fine..going down..exhaust
Hi I have a 1994 k1500 350 tbi and have been chasing a problem with intermittent rough idle and low idle in gear runs fine when reved and going down the road and I can also hear a quiet muffled backfi… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
18,861 satisfied customers
92 lumina: acceleration..my scan tool,fuel pressure reg new..egr
92 lumina car 3.1 lack of acceleration all vacuum lines ok MAP good but only pulls down 1.9-2.1 volts on my scan tool,fuel pressure reg new, no back pressure exh cat back removed ,o-2 new,IAC checked … read more
Dave Nova
Dave Nova
Chevrolet Technician
Associate Degree
7,092 satisfied customers
96 suburban: new engine..ran great..then engine light came..rough
I have a 96 suburban 5.7 that recently had a new engine installed. ran great for a while then engine light came on and code p0106, and a multiple cylinder misfire code. Engine is hard to start and isl… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
98 C2500: 5.7 vin R 176..fuel pressure..driven..my shop
98 C2500 5.7 vin R 176,000 mi.The problem first occured when the truck felt like it was running out of gas, adding 13 gal & seafoam seemed to solve the problem (34 gal. tank & 67 psig fuel pressure).3… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
Chevrolet S10 1987 Chevy S10 w/ 2.8 V6 -- Hard to start --
1987 Chevy S10 w/ 2.8 V6 -- Hard to start -- when it does start it is rough for a few seconds then goes perfect smooth idle, if you accelerate slowly it comes up to full RPM smoothly, If you give it q… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
23,044 satisfied customers
2000 malibu: bein my favorite mechanic i thougth id start with you.
hey dan. bein my favorite mechanic i thougth i'd start with you. i have a 2000 malibu. idle keeps going up the down up then an… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,997 satisfied customers
Chevrolet K3500 2x2 89 Chevy 1 Ton 350 TBI Calf Smog Truck
89 Chevy 1 Ton 350 TBI Calf Smog Truck started few months ago in that it has very little low end most of time. After 2000 RPMs at hwy speed seems to run ok. 90% of time I can put in neutral for 20 sec… read more
Shannon Martin
Shannon Martin
retired
Vocational, Technical or Trade Scho
572 satisfied customers
Chevy: 103k miles, it smoke at idle when it..balancing..shore..inj
i have a 02 chevy duramax with 103k miles, it smoke at idle when it gets worm, i have a anilize and check the balancing rate. but not shore what it should be,i think i have inj, bad. the rate cyl1 -.0… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,931 satisfied customers
1988 GMC: no vent window) timing and iac counts creep..untill
I have a 1988 GMC 3500 4x4 454 truck (no vent window) timing and iac counts creep up at idle and wont come down untill you shut it off.… read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
9,106 satisfied customers
1998 with error code P0452. Is this enough to determine what
1998 with error code P0452. Is this enough to determine what needs replaced? Thanks in advance for any help. Gary… read more
Daniel Jones
Daniel Jones
High School Diploma
476 satisfied customers
1989 caprice: Initial MAP voltage is 4.75...car it drops to about 1
1989 caprice 305. Initial MAP voltage is 4.75. when I start the car it drops to about 1 and then goes up to 2-3 while driving. What should be the idle and driving voltage (Altitude less than 1,000 ft.… read more
mlappert
mlappert
High School or GED
34 satisfied customers
ive got a 91 k1500 4.3l. runs real lean. map sensor voltage is .75v
i've got a 91 k1500 4.3l. runs real lean. map sensor voltage is .75v at idle. i hooked vac pump to map at 12.5" vacuum i have 1.5volt, motor idles great, but vac guage reads 16" if I pump map to 16" v… read more
Jesse
Jesse
GM master Technician
Vocational, Technical or Trade Scho
118 satisfied customers
88 CHEVY G30 CUTAWAY VAN. 350 TBI. ENGINE STALLS OFF IDLE.
88 CHEVY G30 CUTAWAY VAN. 350 TBI. ENGINE STALLS OFF IDLE. WORSE WHEN COLD. 30k ON NEW LONG BLOCK. TBI CLEANED. TPS CHECKS OK. TEMP SENSOR CHECKS OK. NO CODES ON SCANNER. NEW FUEL PRESSURE REGULATOR, … read more
JONATHAN
JONATHAN
JAGUAR/LAND ROVER SHOP FOREMAN
High School or GED
286 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,931 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

18,861 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

Technician

3,187 satisfied customers

24 years of experience diagnosing & repairing

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

Mike S.

Mike S.

Chevy Mechanic

2,317 satisfied customers

ASE Certified Master Technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x