Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
Reduce power mode. I have a 2010 Chevy 2500 throwing reduce
I have a 2010 Chevy 2500 throwing reduce power mode. When u plug a pocket scanner to it it says po1o2 which is mass air flow sensor . Replaced it and it continues to throw throw P0102 replaced EGR valve still reduce power and P102 code. … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,644 satisfied customers
I have a 05 silverado I had a code for mass airflow sensor
I have a 05 silverado I had a code for mass airflow sensor so I replaced it. Also did plugs and wires had a misfire. Before I did this my truck would intermittently stall out and sometimes not start b… read more
vwtech0405
vwtech0405
VW Technician
Associate Degree
10,012 satisfied customers
Intermittent stalling while driving, seems like a lack of
intermittent stalling while driving, seems like a lack of fuel. after sitting for a few minutes it will run and then not have an issue for days. the other night while driving in rush hour traffic it s… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,644 satisfied customers
I have a 4.3 v6 k1500 and my truck is stalling when i come
i have a 4.3 v6 k1500 and my truck is stalling when i come to a stop. I've changed my IAC valve EGR valve and Mass air flow put fuel injector cleaner in it and its still doing it so i ran some codes a… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,977 satisfied customers
I have an 05 colorado with the 2.8. I was driving last week
I have an 05 colorado with the 2.8. I was driving last week and got the mass air flow/map correlation code. I have always had the P0017 code, but the p0300 miss fire code came this week. The truck run… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
Stalls at speed and cuts off while driving. No check engine
Changed Ignition Control Module, checked Mass Airflow Sensor, … read more
Mechanic01
Mechanic01
8,462 satisfied customers
It starts good but when I put it in gear and press the gas
It starts good but when I put it in gear and press the gas it hesitates and cut off I done 2 mass airflow sensors cause I get code p 102 but still same problem I'm ready to drive my truck again help p… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
I'm receiving a p0300 and p0302 error code. I know 0300 is a
I'm receiving a p0300 and p0302 error code. I know 0300 is a random misfire and that 0302 is a misfire for cylinder 2, I've replaced the plugs and wires, I checked the cap and rotor(they have less tha… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,692 satisfied customers
I have a 1999 Chevrolet c1500 with the vortec 5.7 350. My
I have a 1999 Chevrolet c1500 with the vortec 5.7 350. My problem is it's missing at speeds above 45 mph with steady or light throttle. Let off the gas it quits or give it more than a 1/4 gas it quits… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
Chevy S-10: I have a 2003 Chevy S-10 4.3 4WD. Im popping a
I have a 2003 Chevy S-10 4.3 4WD. I'm popping a code p0101. I replaced my mass airflow sensor 3 times this weekend. Whats happening is my truck will not go over 40 mph and is very sluggish, no power a… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
O2 and evap monitors wont clear for my 2003 Silverado
My O2 and evap monitors won't clear for my 2003 Silverado 2500HD LT 6.0L (gas) truck. My battery died about 2 months ago and I first tried charging it over night, then I ended up replacing the battery… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1998 camaro: v6..motion and use the brakes the car stalls out..dies
i have a 1998 camaro v6 3800. the car start and idle just fine but when i am in motion and use the brakes the car stalls out. but starts up just fine and dies out when trying to stop. ive already chan… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1987 coupe: maf, fuel pump relay, ecu, alternator, o2 senser
I have a 1987 coupe. My problem is a SES with a code 33. I have replaced the MAF, fuel pump relay, ECU, alternator, O2 senser, Oil pressure switch and relay, fuel filters,and I am still having this pr… read more
AutoTech36
AutoTech36
High School or GED
164 satisfied customers
96 chevy suburban: black fouling the spark plugs.found
96 chevy suburban 5.7,2500. runs terrible. black fouling the spark plugs.found that it had a leak inside intake. replaced entire unit-spider injection-still runs bad. 1345 code, distributor out of tim… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
2004 Chevy Silverado 2500: Service engine light is on..coil packs
I have a 2004 Chevy Silverado 2500. Service engine light is on and the computer reads mulit-cylinder misfire. Was told possible coil packs. Should I change all eight or is there a way to tell which on… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,644 satisfied customers
2006 Chevrolet: PCM..Voltage..stalling..the truck to the dealership
My 2006 Chevrolet Avalanche is throwing 2 OBD II codes: P0107 MAP Sensor Circuit Low Voltage P0641 PCM Voltage Out of Tolerance Condition on 5-volt reference circuit I'm having problems with the engin… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,644 satisfied customers
I have a 2006 Chevy Malibu with a 2.2L 4 cylinder engine. The
I have a 2006 Chevy Malibu with a 2.2L 4 cylinder engine. The engine started running rough and would stall after 4000 RPM. After the shop replaced the crankshaft position sensor and cleared the error … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,644 satisfied customers
1992 chevy: lumina..easiest way..a clutch, it also needs a starter
Do you have to pull the engine to replace a clutch in a 1992 chevy z34 lumina or what is the easiest way to change this?? How long doe sit normally take for this job. It was a car that Dad gave to my … read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,004 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,977 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

3,023 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x