Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
I have a 96 camaro 3.8 with 43,000 miles.it starts hard cold
I have a 96 camaro 3.8 with 43,000 miles.it starts hard cold and idles low at about 500 rpm.when it warms up the idle comes up to about 1000 rpm.i cleaned the throttle body.a shop put on a new iac,thr… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,688 satisfied customers
I got a 2000 malibu 3.1 just had head and intake gaskets done,
I got a 2000 malibu 3.1 just had head and intake gaskets done, car can't idle smoothly until full operating temp is reached. after it cools down some it acts up and shudders unless I accelerate to kee… read more
Ted G.
Ted G.
Sales Manager
Vocational, Technical or Trade Scho
5,629 satisfied customers
Chevrolet Tahoe: after changing intake gaskets the engine will
after changing intake gaskets the engine will no longer idle at low idle. It remains at 1800 to 3000rpm and will not come back down. we have changed the TPS, IAC motor and have checked fot air leaks. … read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
Chevrolet K1500 4x4: I have a 1996 K1500 350 with mpfi. I have
I have a 1996 K1500 350 with mpfi. I have a high idle (at least 1500 or more) in cold weather and even when the engine is at op. temp, the idle remains very high. A little history: the vehicle seemed … read more
K. Wiggins
K. Wiggins
ASE Certified Technician
Associate Degree
3,964 satisfied customers
Chevrolet Blazer 4x4 (Mid Size): Hello, I have a 2000 4WD blazer
Hello, I have a 2000 4WD blazer with a 4.3 V6. My issue is that if the outside temp is below 30 degrees when I start it in the morning, it does not come off of high idle (about 1100 rpm) unless I let … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,598 satisfied customers
Chevrolet Lumina: 97 Lumina idles very fast. I replaced the
97 Lumina idles very fast. I replaced the TPS and IAC but still have the same issue. I am wondering if I did not install the IAC correctly. When installing, I extended the pintle and the car idled a l… read more
Dave Nova
Dave Nova
Chevrolet Technician
Associate Degree
7,092 satisfied customers
My Chevy Tracker has a low rough idle after it warms up
Hello, I have a 2003 Chevy Tracker with a Suzuki 2.0L 4 cylinder engine. It has a low rough idle, after it warms up. Runs good cold and when you accelerate, but with a 500 rpm idle. With AC on and in … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,598 satisfied customers
put in a rebuilt 5.7 im my 4x4..thing hooked..it runs about 2000 rpm
91 K2500 really high idle I just put in a rebuilt 5.7 im my 4x4. and have every thing hooked up, started it and it runs about 2000 rpm. It had power off to the computer for 3 months, but it seems to b… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,088 satisfied customers
1999 Chevrolet Tahoe: 5.7L..High Idle..000 rpm..the idle speeds
1999 Chevrolet Tahoe (5.7L) - High Idle in Cold: This is my second attempt with Just Answer. After two years of diagnosis I can still not figure out why my vehilce continually idles at 1,000 rpm when … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,020 satisfied customers
1994 lumina: van..injector..kick..tempature temp gauge
1994 lumina van engine surges at speed idle fine replaced one injector because it appeared to be not working all the time, fan doesn't kick on at tempature temp gauge doesn't work replaced temp switch… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,088 satisfied customers
1994 suburban: K1500..traffic..out, always stalls..accelerator
I have a K1500 1994 suburban about 200 K miles. Idle has been running a little rough for about 12 months . Recently began stalling when at a light or stop/go traffic, the engine usually hiccups a few … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,088 satisfied customers
1996 chevy blazer: 4.3..high idle..30mph..releasing..brakes
we have a 1996 checy blazer 4.3 that has a 507 high idle IAC responding code, we replaced the IAC but nothing changed. When driving it feels like the accelerator gets stuck about 30MPH and the only wa… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
1998 chevy: u 4wd 5.7 vortech it only starts..degrees..cranks..55 psi
I have a 1998 chevy p/u 4wd 5.7 vortech it only starts when its 65 degrees + when its cold it cranks and kicks back against the starter,flutters a little like it wants to ,has no codes ,55 psi fuel at… read more
Scott
Scott
Manager/Technician
Associate Degree
1,618 satisfied customers
silverado..truck runs rough idle..stalls..Service engine..it runs fine
2002 silverado, 4.8 l, 4wd On extreme cold starts, temps lower than -10*c overnite, the truck runs rough idle, up and down from 1200 rpm to 400 rpm, and likely stalls. Service engine lite may or may n… read more
Paul M ASE Master
Paul M ASE Master
Automotive College
4,606 satisfied customers
1987 chevy: idling..the IAC unit, drove it for a few days..cylinders
What is the purpose of the PCV valve in a 1987 chevy 3500 crew, 454tbi? I was discussing idling/running problems with you last week. I replaced the IAC unit, drove it for a few days, seemed to run ok,… read more
reverend thomas sparacino
reverend thomas sparacino
head mechanic
Vocational, Technical or Trade Scho
10 satisfied customers
2000 Chevy metro: no codes come up but the gas rpm sits at 2000..idle
2000 Chevy metro. i start the car and no codes come up but the gas rpm sits at 2000 on idle..… read more
Billy
Billy
Shop Foreman
Vocational, Technical or Trade Scho
510 satisfied customers
1989 Z24 Cavalier - 2.8L 5 spd - Idle flucuations.
1989 Z24 Cavalier - 2.8L 5 spd - Idle flucuations. Will work fine for a while then it want to idle at 2500 to 3000 RPM until you come to a complete stop then idles rough at 800 RPM. When you start it … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,088 satisfied customers
1994 Cavalier RS: tool..procedure to allow the ECM/PCM memory..rebuild
I think my starter is gone on my 1994 Cavalier RS 3.1L FI.Chilton's says I need a "scan tool" to "perform the idle learn procedure to allow the ECM/PCM memory to be updaated with the correct IAC valve… read more
Bob
Bob
Vocational, Technical or Trade Scho
2,784 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,004 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,977 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

3,023 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x