Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
My 98 silverado 2500 4x4 sometimes starts and dies after 1
My 98 silverado 2500 4x4 sometimes starts and dies after 1 second. I have to leave it sit for a while then it starts.Why? It also has no power and runs rough when I step on it.… read more
Mike V.
Mike V.
technician
Subaru and Nissan factory training.
29,605 satisfied customers
98 Chev K1500 5.7. We have a driveability problem. It idles
98 Chev K1500 5.7. We have a driveability problem. It idles fine and does good under hard acceleration. Just off idle even with no load, (truck in park) the engine runs really rough as soon as you go … read more
Ron
Ron
Automotive Tech
Vocational, Technical or Trade Scho
39,509 satisfied customers
2001 chevy 4.3 blazer have replaced fuel pump, crank sensor.
2001 chevy 4.3 blazer have replaced fuel pump, crank sensor. will start and run when cold after warming up will shut down only running about 75 feet. starts runs real rough and then quits.… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
Chevrolet HHR: I am having issues with my 2008 Chevy HHR 2.0
I am having issues with my 2008 Chevy HHR 2.0 turbo. I have literally changed every sensor. For some reason it is still throwing a mass air flow and barometric sensor code. We have replaced them twice… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
Chevrolet Malibu LT: Hi Moose! David here. Have a 2011 Malibu,
Hi Moose! David here. Have a 2011 Malibu, 83K miles 2.4 cyl. w P1174. Read codes, no others set.reset code, comes back on immediately like within a few minutes. Motor has Zero symptoms. runs fine star… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,675 satisfied customers
Chevrolet Impala LS: 2003 chevy impala 3.8 . Trouble cold starting,
2003 chevy impala 3.8 . Trouble cold starting, stalls when cold and coming to a stop. The check engine light came on and it had high idle. Put it on a scanner. I replaced the idle control valve. That … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,495 satisfied customers
Rough idle first thing in the morning, unplugged maf and it
Rough idle first thing in the morning, unplugged maf and it ran fine,have already swapped this out putting mine on brothers and vice versa. His runs fine and mine still runs like crap… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
33,167 satisfied customers
2007 chevy: mass air flow sensor..replaced twice..5000 miles
I have a 2007 chevy 5500 8.1 that the mass air flow sensor keeps failing on. It's been replaced twice now in under 5000 miles.… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
20,925 satisfied customers
p300: silverado..automatic..power and the check engine light came on
i have a 2005 silverado 4.3 automatic the other day it started to loose power and the check engine light came on. i had it scanned and came up with these codes PO101 PO128 PO300 PO756 what should i do… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
33,167 satisfied customers
2000 chevy: 4x4..timing..plugs,cap,rotor,wires,fuel pump..air filter
2000 chev k2500 5.7 standard 4x4 has code 122 have replaced throttle position switch no help. engine revs up on its own and has no power like timing problem but have changed plugs,cap,rotor,wires,fuel… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
Tahoe: change distributor, cap and button, fuel pump, plugs, coil
My 98 chev tahoo is miss firing, change distributor, cap and button, fuel pump, plugs, coil and I unplugged mass air flow sensor, un hooked O2 sensors, scanner reads no hard codes. Please help $800.00… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
99 chevy blazer: 4x4 4.3 v-6 vortec...distributor,cap,rotar,wires
I have a 99 chevy blazer 4x4 4.3 v-6 vortec. I just replaced the distributor,cap,rotar,wires,and plugs. We have also just replaced the head gaskets and etc. Aprox a month ago we replaced trhe fuel pum… read more
Dan
Dan
High School or GED
2,257 satisfied customers
chevy: 4x4..low voltage and code po340..AIR FLOW SENSOR..smooth
I have a1998 chevy 4x4 350 with code po102,mass air flow circuit with low voltage and code po340,camshaft position sensor A circuit HAVE REPLACED MASS AIR FLOW SENSOR STILL GETTING FAULTS ;ENGINE RUNS… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
98 chevy blazer: 4x4 4.3L SES light..a sensor problem.
98 chevy blazer 4x4 4.3L SES light on engine will not exceed 2400 rpm in drive, rpm fine with no load. is this a sensor problem.… read more
Dan
Dan
High School or GED
2,257 satisfied customers
03 6.0 chev that is reading 2 diff sys too lean codes..air flow..cyl
I have an 03 6.0 chev that is reading 2 diff sys too lean codes (both banks) and a mass/vol air flow circuit range/perf code. plus a random/multi cyl. misfire detected code. Has new plugs n wires, and… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,675 satisfied customers
98 s10 blazer: idles..the iac , tps, and the mass air flow sensor
i have a 98 s10 blazer 4.3 l it idles at 1500 when warm in park and 1000 rpm in drive have changed the iac , tps, and the mass air flow sensor, if you tap on the map sensor the truck will idle higher … read more
stin1974
stin1974
Mechanic/Technician
High School or GED
84 satisfied customers
1999 tahoe: leaking manifold..about 30 mile and the light came
I have a 1999 tahoe 5.7 lt. I pulled 2 codes po171 & po174 both banks running lean. Heres the funny part everyone says a leaking manifold gasket. But when I filled it up the light turned off I drive a… read more
Dan
Dan
High School or GED
2,257 satisfied customers
97 chevy malibu: the obd code PO102 mass air flow circiut.I
I have 97 chevy malibu that is showing the obd code PO102 mass air flow circiut.I changed m.a.p sensor,mass airflow sensor, throttle position sensor, and still has the same code.I check the fuse.,cant… read more
ZZDaryl
ZZDaryl
Lead Auto Tech
Some college and advanced training
11,483 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,004 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,977 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

3,023 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x