Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
I have a 06 Silverado 2500hd 6lt gas 135000 miles at highway
I have a 06 Silverado 2500hd 6lt gas 135000 miles at highway speeds above 70 miles per hour. Below are items from freeze frame along with items replaced. FREEZE FRAME ITEMS REPLACED Short Term Fuel B1… read more
GM Bob
GM Bob
Automobile Technician
High School or GED
1,116 satisfied customers
1998 Tahoe 5.7, misses/backfires horrible over 1/2 throttle.
1998 Tahoe 5.7, misses/backfires horrible over 1/2 throttle. Have replaced; distributor, coil, ignition module, plugs, wires, crank sensor, spider injection assembly, fuel filter. Fuel psi is 55 koer,… read more
Clayso
Clayso
Shop Owner Master Technician
ASE Master Certified Automobile Technician
879 satisfied customers
Chevrolet Silverado 1500 Classic LS: I have a 2003 Chevrolet
I have a 2003 Chevrolet Silverado 1500 5.3l. To make a long story short, the truck has new plugs, wires, air/fuel filters, knock sensors & harness, intake gaskets, crank sensor, fuel pump module, and … read more
sprinkles08
sprinkles08
Technician
High School or GED
18,924 satisfied customers
Chevrolet K3500 4x4: 96 K3500 7.4L P0102 sets during KOEO test
96 K3500 7.4L P0102 sets during KOEO test only. Code will not set if engine is running. B+ voltage good, ground good, signal from computer 5v.… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
can you explain what this means concerning my 04 chevy
can you explain what this means concerning my 04 chevy express 1500 4.3 . P0016 crankshaft position - camshaft position correlation Bank 1 sensor A… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
im working on a 2001 chevy 2500 6.0,,,,got a mass air flow
im working on a 2001 chevy 2500 6.0,,,,got a mass air flow code and replaced it,,truck still running rough and has no power,,,still has codes po101 and po300,,,,i also replaced intake gaskets,,,checke… read more
David H
David H
Vocational, Technical or Trade Scho
2,678 satisfied customers
Chevrolet Monte Carlo: I have a 2003 Chevrolet Monte Carlo
I have a 2003 Chevrolet Monte Carlo 3.4L with DTC P0453 and P1635. It idles at 2500 - 3000K RPMS. TPS with scanner connected has a reading of 18 - 24 while sitting at idle. All other sensor readings a… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
torque converter alignment went great.you..revs..rough
the torque converter alignment went great.you saved me alot of time. One more question,the engine is now installed and when statrted revs high and rough . I have heard the computer needs a relearn. An… read more
George H.
George H.
Technician
Associate Degree
19,159 satisfied customers
silverado 1500: chev..3 fuel pumps..intermittant stalling , code p1626
2003 chev silverado1500 5.3L Have installed 3 fuel pumps on this truck all AC delco pumps w/harness, cameback intermittant stalling, code P1626. had remote start system,completely removed and replaced… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
2004 Chevy: fuel pressure test..kicks..it drops..fuel system
2004 Chevy Express Van 2500 w/ 4.8L dumping fuel and will not start. I did a fuel pressure test and have 60 psi as soon as the fuel pump kicks on, and it drops right down to zero after the pump cycles… read more
David H
David H
Vocational, Technical or Trade Scho
2,678 satisfied customers
99 chevy: 1500 4x4..changed fuel filter..an check air filter..air box
ihave a 9/99 chevy 1500 4x4 im working on because of a lack of power and flashing engine light,i have retrived multiple codes,po101,po137,po154,po155,po157,and the last po300.So far we have changed fu… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
20,925 satisfied customers
1990 chevy cavalier z24: egr,crank sensor..control module..car starts
i have a 1990 chevy cavelier z24. i have put in new ignition module, coils,egr,crank sensor and finally the computer control module plus a new fuel pump and strainer. car starts, runs rough and then d… read more
Hal
Hal
owner/service tech
Vocational, Technical or Trade Scho
925 satisfied customers
1995 corvette: i start out the car backfires and misses..2000 rpm
I have a 1995 corvette with 5.7 automaticwith 108000 miles. When i start out the car backfires and misses between 1200 and 2000 rpm hot or cold .Some times it will drive well with no trouble. I have r… read more
Ted G.
Ted G.
Sales Manager
Vocational, Technical or Trade Scho
5,628 satisfied customers
I HAVE 96 CHEVY TAHOE LS 5.7 VORTEC DTC FOR CAMSHAFT SENSOR
I HAVE 96 CHEVY TAHOE LS 5.7 VORTEC DTC FOR CAMSHAFT SENSOR REPLACED IT THEN THROWS PO304 CYLINDER #4 MISFIRE, IT AT TIMES WOULD THROW PO300 BUT MOSTLY PO304 ALONG WITH PO102 ,OK I'VE REPLACED TPS,IAC… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,394 satisfied customers
96 chevy: a 5.7 vortec engine..dtc..Fuel pressure..koeo
I have a 96 chevy 2500 with a 5.7 vortec engine with hard to start conditions when engine is cold and dtc p0122. Fuel pressure is at 55-56psi with koeo and 52psi with koer at idle. I am thinking press… read more
hauto
hauto
Operate own repair shop
Bachelor's Degree
2,719 satisfied customers
2004 GMC: 5.3L..LEFT BANK..60 psi ,.COMP is GOOD.SEEMS TO BE MISFIRING
2004 GMC 1500 4/4 5.3L,CODES ARE PO300 AND P0171.SPARK PLUGS R BLACK ON LEFT BANK,ENHAUST IS BLACK.FUEL PRESSURE IS 60 PSI ,.COMP IS GOOD.SEEMS TO BE MISFIRING ON LEFT BANK.WHAT ELSE IS THERE TO CHECK… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
16,004 satisfied customers
2004 Isuzu ascender: po171..p300..a tune up and cleared codes
2004 Isuzu Asender 4.2 has a running prblem. had codes po171,po172 po300 po410 . did a tune up and cleared codes. drove car and runs sluggish.RPM top out at 2500.Went thru relearn RPM came back to 350… read more
brad
brad
Vocational, Technical or Trade Scho
10 satisfied customers
1985 Ford Econoline: stalling problem..same problem..Distributor..Coil
1985 Ford Econoline with EEC-IV TFI FBC having a stalling problem after about 5-10 minutes of idle or driving. After a 30 minute wait will start and run for another 5-10 minutes: Swaped following but … read more
JONATHAN
JONATHAN
JAGUAR/LAND ROVER SHOP FOREMAN
High School or GED
286 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,004 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,977 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

3,023 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x