Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
Got a stroker 383 ci car always runs at 190 degrees 2
Got a stroker 383 ci car always runs at 190 degrees 2 electric fans big aluminum radiator been sitting for a couple months. The temp out side is 60 degrees I start it and it's at 230 by the end of my … read more
adam warren
adam warren
Master auto tec
233 satisfied customers
I'm having a miserable time getting my 2000 Chevy c3500 to
I'm having a miserable time getting my 2000 Chevy c3500 to read the catalyst monitor. I've been doing the GM drive cycle repeatedly and it's the one monitor that won't read, any ideas? … read more
Jerry Newton
Jerry Newton
Chevy Technician
Vocational, Technical or Trade Scho
2,804 satisfied customers
2005, chevy express 1500 passenger van. Intermittent blower
2005, chevy express 1500 passenger van. Intermittent blower motor comes on when key is off, and removed. Fuse is good. Relay works. Switched relays and same issue. While this is happening sometimes ve… read more
Roy
Roy
shop foreman
Associate Degree
5,217 satisfied customers
I have 2002 Chev Tracker 2.0 litre L4 auto and check engine
I have 2002 Chev Tracker 2.0 litre L4 auto and check engine light came on after it stated in drive. A couple days before this the RPM went from 3000 RPM to zero while I was on freeway , chugged a bit … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
19,780 satisfied customers
I have a 383 stroker motor that I need to put in my 1990
I have a 383 stroker motor that I need to put in my 1990 K2500. It is carbuerated so I need to know what I need to do to convert it to from the EFI. … read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,409 satisfied customers
Have a 91 z28 convertible. Needs new top and the tpi,
Have a 91 z28 convertible. Needs new top and the tpi, computer and wiring harness are gone. Transmission and brakes worked fine when last moved (almost 8yrs ago). What's the best route to take in fixi… read more
K. Wiggins
K. Wiggins
ASE Certified Technician
Associate Degree
3,960 satisfied customers
Chevrolet Camaro IROC-Z: Hello my name isXXXXX and
Hello my name isXXXXX and I have a 1988 camaro, I'm doing an engine swap to a carburated 383 stroker, non computer controlled. Can you guid me through the steps of getting the set up to work, I know i… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
Dr. Hamman, You have helped me out in the past and I just
Dr. Hamman, You have helped me out in the past and I just wanted to get your opinion on this since you too have a 383 Stroker motor... I have an 87' Chevy Camaro IROC-Z. Pretty much totally modified/o… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
Chevrolet K1500 4x4: I have a 1998 chevy 4x4 ext cab truck
How to swap a 4l60e for a 700 R4.I have a 1998 chevy 4x4 ext cab truck with a 383 stroker engine built by GM performance to replace the 5.7L vortec 350. I have a cold air intake and a jet performance … read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
17,187 satisfied customers
Chevrolet C10 4x2: I just swapped out a factory 350 in an 84
I just swapped out a factory 350 in an 84 c10. I put in a 383 stroker (used a 79 model block). Prior to the swap the 700r4 auto transmission was working great. After I installed the new torque convert… read more
K. Wiggins
K. Wiggins
ASE Certified Technician
Associate Degree
3,960 satisfied customers
Chevrolet corvette: Im looking to buy a 1977 corvette it has
Im looking to buy a 1977 corvette it has a 383 stroker with 3 speed auto 350th transmission with 2800 stall converter all new. the car is in good condition but im told that the gas Mileage with the 3 … read more
Ted G.
Ted G.
Sales Manager
Vocational, Technical or Trade Scho
5,628 satisfied customers
1980 corvette: hey guys...garage..wiring..electrical components
hey guys. I have inherited a 1980 corvette that has been in a garage for about four years. the wiring is intact and all the electrical components work. It has a 383 stroker with 10:1 compression, unkn… read more
Dave Nova
Dave Nova
Chevrolet Technician
Associate Degree
7,092 satisfied customers
1992 Chevy: cab..5.7L V8 Automatic/full power..overheating..trans
Good day, I have a 1992 Chevy CK1500 single cab Stepside 5.7L V8 Automatic/full power - almost 300k miles...runs nice, some overheating problems, trans needs rebuild. (slips just a little from 1st to … read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,409 satisfied customers
GM: you buy a remanufactued long block for a 383 stroker
Would you buy a remanufactued long block for a 383 stroker or a new GM - Eagle made long block. If remanufacture from whom woulf you buy. Ron in Arizona… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,659 satisfied customers
89 chevy: I currently hanve A 2.5 liter 4 cylinder..rear end..bolt
I am thinking of putting a 383 stroker motor in a '89 chevy s-10 I currently hanve A 2.5 liter 4 cylinder in it. Would like to know if a camaro rear end with disc brakes would be the best route to get… read more
john c.
john c.
Associate Degree
235 satisfied customers
The biggest engine I can using a 4 bolt gen 5 454 block..bore
I'm wanting to build the biggest engine I can using a 4 bolt gen 5 454 block. so what i would like to do is bore it as big as safely possible. thanks… read more
Matt J
Matt J
Owner of Jones Automotive
Vocational, Technical or Trade Scho
1,396 satisfied customers
I HAVE A 1966 CHEVY C-20 PICKUP WITH COIL SPRINGS AND 1/4 ...
I HAVE A 1966 CHEVY C-20 PICKUP WITH COIL SPRINGS AND 1/4 TON LEAF SPRING OVERLOAD. THE GEAR RATIO IS 457. IT IS A EIGHT LUG REAR END. IT HAS A 327 ENGINE AND A FACTORY TURBO 400 TRANSMISSION. IS THER… read more
frank
frank
Vocational, Technical or Trade Scho
1,892 satisfied customers
vette..old water pump..80 miles in it blew, over heated and bet 2
I recently had a 383 stroker built and installed in my 1980 vette. The old water pump was used on the new enging, don''t ask me why, cheap mechanic I guess. 80 miles in it blew, over heated and bet 2 … read more
Dan
Dan
Auto Technician
Associate Degree
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

16,004 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,659 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

17,187 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

3,023 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Jerry Newton

Jerry Newton

Chevy Technician

2,804 satisfied customers

ASE Master Technician, L1, Master GM Technician. Over 20 years of bumper to bumper GM experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x