star-filledicon-cnnicon-foxicon-nbcicon-nyticon-today

Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Chevy Questions
Chevy 85 caprice.. i have a reman 4.3 v6 tbi. valves
Chevy 85 caprice.. i have a reman 4.3 v6 tbi. valves readjust after 800 miles oil change. Plugs wires dist cap and rotor, o2sensore,new iac, map, tps, temp sensor for ecu. My car seems to back fire af… read more
Pete
Pete
Auto Service Technician
General auto certifications
34,726 satisfied customers
Second opinion] Chevy 85 caprice.. i have a reman 4.3 v6
Second opinion] Chevy 85 caprice.. i have a reman 4.3 v6 tbi. valves readjust after 800 miles oil change. Plugs wires dist cap and rotor, o2sensore,new iac, map, tps, temp sensor for ecu. My car seems… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,642 satisfied customers
I just replaced the distributor on a 1986 chevy s10 blazer
I just replaced the distributor on a 1986 chevy s10 blazer 2.8 and it turns over nice but won't start. no backfiring at all. I replaced the distributor because of backfiring aftr a tuneup. found the s… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
I have a 93 s10 blazer cpi. i need help to set timing. timing
i have a 93 s10 blazer cpi. i need help to set timing. timing marks dont line up with top dead center. got it to start, (timing marks way off)but would only stay running while giving it gas and was ve… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
Chevrolet S10 Blazer 4x2 tahoe: HI-i have a 1994 s10 blazer
HI-i have a 1994 s10 blazer tahoe 4.3 auto trans 2wd-one day on freeway began running rough-stumbling-acting like it was out of gas-pulled over smoke under vehicle then fire-FD put out fire(it was onl… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,642 satisfied customers
Chevrolet S10: 1988 chevy s10 pickup, 4.3L, A/T, P/S, P/,
1988 chevy s10 pickup, 4.3L, A/T, P/S, P/B, A/C, C/C - No start / hard start and dies immediately when it does start - idle never gets above 550rpm - Raw Fuel Smell Items replaced - 1) Dist Cap, Rotor… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,324 satisfied customers
Chevrolet S10 Blazer 4x4: my 91 s10 blazer will not stayrunning.
my 91 s10 blazer will not stayrunning. i have replaced the fuel tank ,which had a hole in it, fuel filter, egr, tps iac, cap rotor plugs and wires. Sounds better when runs but will not stay running. w… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
1994 Chevy Blazer: then my mechanic..spark plugs..rotor..fuel pressure
Why won't my 1994 Chevy Blazer start? It died on the freeway 2 wks ago, since then my mechanic has replaced the fuel pump, fuel filter, spark plugs, cap and rotor last week, but it still didn't start.… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,055 satisfied customers
s10 blazer 4x4: drove..160 alittle ritch tps fine no vacum leaks..egr
i have an s10 blazer 4x4 with a vortec 350 and powerdyne supercharger ! its been tuned by westers garage in canada the motor has been fine for over 4 years now sense i drove to work on thursday its be… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
10 blazer: fuel pressure..egr..tps, vacume control module..distributor
I have a 89 chevy s-10 blazer, It seems to be not getting enuff fuel. I've checked the fuel pressure and its at 12lbs. I've replaced the following parts cat & muffler, on board computer, (not getting … read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
1990 Chevy truck: rough idle..injector screens..cap..rotor
1990 Chevy truck was running very lean (white plugs) with a rough idle. I changed the map sensor, ect sensor, iac valve, fuel pump and filter, checked the tps sensor and its good. also changed injecto… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
I bought a new 350 crate engine part number 12568758..timing..bypass
I bought a new 350 crate engine part number 12568758 to replace the old 14093638 engine and I can't get the timing right. What could be the problem? I unplug the connection to put it in bypass mode. S… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
93 s10: AT 4x4 with 72k mi on it..first start..take about 3-5 trys
I have a 93 s10 4.3 AT 4x4 with 72K mi on it. It has been idling rough. When it is cold in the mornings and you first start it it will take about 3-5 trys before it will idle on its own. Or you can st… read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
8,884 satisfied customers
1995 chevy s10 blazer: engine runs..operating temp..sputters..stalls
i have a 1995 chevy s10 blazer 4.3 litre engine a cold engine runs perfect when it reaches operating temp it sputters and stalls do you know why… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
1992 chevy: 4X4..blazer, about 250,000 miles..two problems
1992 chevy full size 4X4 blazer, about 250,000 miles. I think there are two problems. 1. It was running fine with just an occassional miss at idle but ran fine at highway speeds. Suddenly, at a stop, … read more
Triston
Triston
High School or GED
1,613 satisfied customers
1996 s10 Blazer: VIN..that has DTC 507, HIgh Idle..stick
I have a 1996 s10 Blazer 4.3 VIN W that has DTC 507, HIgh Idle. The idle seems to stick high at times. It has a new IAC motor, no known vacum leak. Is there something else causing this?… read more
mackin1
mackin1
Vocational, Technical or Trade Scho
216 satisfied customers
97 chevy: timing gears..screwdriver..#4 are tdc..distributer shaft
i put the timing gears right on a 97 chevy s-10 blazer and the guy before me had put it off a notch so i redid it now that it is all put together right ( the gears) i put thedistributer on and it will… read more
Bob
Bob
Vocational, Technical or Trade Scho
2,784 satisfied customers
1985 chevrolet: L..manifold..a painless wiring harness for 1990 GM
I have a 1985 chevrolet C-10 pick-up with a 4.3 L engine. I overhauled the engine and put an Edlebrock TBI manifold on it and a painless wiring harness for 1990 GM pick-up. The computer is from a 1990… read more
Matt
Matt
Shop Owner / Technician
Vocational, Technical or Trade Scho
44 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
Pete

Pete

Chevy Mechanic

14 years GM dealer Technician.

34726 Satisfied Customers

Pearl avatarPearl, Assistant

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

15,756 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,642 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,884 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

2,953 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Ron Z.

Ron Z.

- Chevy Tech -

2,836 satisfied customers

18+yrs experience. State Inspector and Chevy Diagnostics

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x