Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
Have a 2000 Chevy Blazer - Vortec V6 4.3L - 4WD - automatic
Have a 2000 Chevy Blazer - Vortec V6 4.3L - 4WD - automatic - about 180K miles. Have had it since about 2003 and was good daily driver for the wife. Eventually the tranny went out and had other small … read more
Roy
Roy
shop foreman
Associate Degree
4,599 satisfied customers
Just replaced lower intake manifold gaskets on a 2001 Chevy
Just replaced lower intake manifold gaskets on a 2001 Chevy Blazer 4.3L w/CPI (W engine). Have read that if distributor is removed that it should be removed at #1 TDC, with it being marked in position… read more
Gary
Gary
Senior Technician
Vocational, Technical or Trade School
2,000 satisfied customers
Chevrolet S10: . i'M HELPING MY FRIEND FIX HIS 1999 CHEVY
HI. i'M HELPING MY FRIEND FIX HIS 1999 CHEVY S10, HE CHANGED THE IGNITION SENSOR( THE ONE ONE THE DISTRIBUTOR) AND DIDNT PUT MARKS AS TO HOW THE ROTOR CAME OUT SO HE COULD PUT IT BACK IN THE SAME WAY.… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,124 satisfied customers
Chevrolet Blazer 4x4 (Full Size): I just installed a new fuel
I just installed a new fuel pump and fuel filter on my 2000 chevy blazer (4.3L v6 vortec 4x4). The pump is kicking on but still won't start. Tried to bleed lines at schrader valve with flat-head screw… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,595 satisfied customers
Chevrolet K1500 4x4: Hey Pete. My Name is XXXXX XXXXX I own an
Hey Pete. My Name is XXXXX XXXXX I own an independent Tire & Auto store in Spokane Wa. A neighboring shop had done head gaskets on a 96 Chev K1500 5.7lt Vortec. The heads were sent to a machine shop t… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,680 satisfied customers
Chevrolet C1500 4x2: I have a 1994chev 350-installed intake
I have a 1994chev 350-installed intake gasket set! Changed oil before droping distributer back in! Now dist won't drop back in place I'd like to find compression stroke to drop in dist in on #1 to my … read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
98 vortec 350 to replace a head gasket..intake..pulling..distributor I
Tore down a barely running 98 Vortec 350 to replace a head gasket and a cracked lower intake. Motor was packed with emulsified oil, so additionally I took the rockers off for cleanup. When pulling the… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,537 satisfied customers
blown head..distributor so it will be correct for the computor
2000 C3500 5.7 Vortec. Replaced blown head gskt. Need to get the correct procedures for installing the distributor so it will be correct for the computor… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,870 satisfied customers
1999 Chevy Tahoe: vortec V..wouldnt start..finished that put coolant
I have a 1999 Chevy Tahoe Vortec V-8. Beginnig problem engine wouldn't start we replaced the spider, upper and lower manifold gaskets. When we finished that put coolant back new radiator cap. Then eng… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
Chevrolet S10 I have a 1996 S10 (4.3L V6 Vortec engine) that
I have a 1996 S10 (4.3L V6 Vortec engine) that is refusing to completely turn over and start. We did have to rebuild the top side of the engine because of blown head gaskets and blown manifold gasket.… read more
Hal
Hal
owner/service tech
Vocational, Technical or Trade Scho
925 satisfied customers
2002 Chevy Astro AWD: 4.3L..mileage..Antifreeze but there are no leaks
I have a 2002 Chevy Astro AWD with the 4.3L Vortec engine. Current mileage is 129K. It is losing Antifreeze but there are no leaks on the outside of the engine. I know that intake manifold gaskets hav… read more
cartech
cartech
master tech
High School or GED
3,324 satisfied customers
1991 s10 blazer 4x4: vin..fuel filter..tbi, replaced all sensors, coil
1991 s10 blazer 4x4 4.3l tbi vin Z / new fuel tank, pump, sending unit, fuel filter, basic rebuild of tbi, replaced all sensors, coil, drove 1700 miles with no issues then developed a miss under load … read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1996 Chevy blazer: 4wd..V6..The TDC was ok on original distributor
I have a 1996 Chevy blazer 4wd V6 vortec 4.3l. I just replaced the distributor cape. The TDC was ok on original distributor. I could not get the new one in the same. So I moved the crank shaft a bit u… read more
ZZDaryl
ZZDaryl
Lead Auto Tech
Some college and advanced training
11,465 satisfied customers
88 caprice: i put a new intake manifold..put back..firing right so im
i put a new intake manifold on my 88 caprice with a 305 and i didnt remember where the distributor was when i took it off so after it was put back on it didnt seem like it was firing right so im not s… read more
Carfix4you
Carfix4you
Lead Technician
Associate Degree
412 satisfied customers
I did a intake gasket and didnt get the distributor in right
i did a intake gasket and didnt get the distributor in right and the light is on in the dash was scaned and the code comformed it how do i relign it so it is in right… read more
ZZDaryl
ZZDaryl
Lead Auto Tech
Some college and advanced training
11,465 satisfied customers
Need to know firing order for 1994 blazer tahoe 4.
need to know firing order for 1994 blazer tahoe 4.3 liter vortec and which side #1 piston is on… read more
Greg A
Greg A
Bachelor's Degree
9,172 satisfied customers
10 Blazer: I have 93 Chev S..4.3L..Vortec..changed fuel pump
I have 93 Chev S-10 Blazer, 4.3L Vortec, have gas to engine but will not fire. I just changed fuel pump in tank(fun,fun), it ran couple minutes after the change and shut off. Now is cranks but does no… read more
Dan
Dan
Auto Technician
Associate Degree
#1 cylinder is tdc and the distributor is pointing..disconnect..timing
#1 cylinder is tdc and the distributor is pointing at the #1 position. I can move the distributor full advance and full retarde with no change. Is there a wire that I must disconnect before the vehicl… read more
marc
marc
fleet supervisor
Vocational, Technical or Trade Scho
1,140 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

15,659 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

18,051 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,884 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

2,953 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Ron Z.

Ron Z.

- Chevy Tech -

2,836 satisfied customers

18+yrs experience. State Inspector and Chevy Diagnostics

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x