Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Chevy Questions
I got a 2001 chevy blazer it has misfires on cylinder 3,5,6
I got a 2001 chevy blazer it has misfires on cylinder 3,5,6 and the barleys runs. I checked the distributor timing and it s spot on, Replaced cap and rotor, spark plugs and distributor itself was repl… read more
mike switzer
mike switzer
733 satisfied customers
Chevrolet Winnebago: 1997 454 in RV. Cranked and ran for short
1997 454 in RV. Cranked and ran for short while, turned off and would not crank. Replaced dist cap and rotor and it cranked, let run for a while, turned off and would not crank....Replaced coil and ig… read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
25,572 satisfied customers
Chevrolet escalade: hello, i have a 1999 escalade with the
hello, i have a 1999 escalade with the 5.7 v-8 in it, I changed the distributor out, put the new one in exactly how the old one came out and i get a DTC code for cam position (p1345 i think) as soon a… read more
GM Bob
GM Bob
Automobile Technician
High School or GED
1,104 satisfied customers
Chevrolet: Have a 1999 GMC C3500, with a 5.7l(R) eng. Will
Have a 1999 GMC C3500, with a 5.7l(R) eng. Will not start, or attempt to start, no spit, backfire or anything. No CEL codes or current codes. Had a P1345 in history code. (Crankshaft -camshaft correla… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,756 satisfied customers
Chevrolet Suburban 1500 LT: 1996 chevy suburban 5.7. Will
1996 chevy suburban 5.7. Will not start when run and shutoff hot. Left to cool a bit will start every time. I have replace the ICU, ignition coil, dist cap, wires & plugs. Starting to think the ECU mi… read more
Canuck Tech
Canuck Tech
Associate
501 satisfied customers
2000 chevy: 2wd automatic..surges..throttle pos sensor truck runs 90%
2000 chevy 1500 4.3l 2wd automatic: jumps/surges when going down road, misses when in park worse @1800rpm. IDEL and starts FINE. If you unplug throttle pos sensor truck runs 90% better and does not mi… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1997 tahoe: van..blown..vin..the coolant bypass nipple off, it threads
Ok, so i have a auto repair shop here in NE Ohio, I had a customer bring me a 2001 gmc van with a blown engine, we replaced the engine with one out of a 1997 tahoe. The engine is a 5.7 vin r, When the… read more
Neal
Neal
Auto repair pro, 30 years experience
Associate Degree
8,213 satisfied customers
98 silverado 1/2 ton with a 350 in it...camshaft sensor..dist
I have a 98 silverado 1/2 ton with a 350 in it. Truck died while driving the other day and would not start....did some research and figured it to the ignition control module....THIS IS WHERE I SCREWED… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,756 satisfied customers
CHEVY blazer: 4.3..ROTOR..CONTROL MODULE..CAMSHAFT..CRANKSHAFT SENSOR
01 CHEVY BLAZER 4.3 NO SPARK AT THE SPARK PLUG OR COMING OUT OF THE COIL...........HAVE REPLACE THE DIST CAP ,ROTOR,IGN CONTROL MODULE,CAMSHAFT PICKUP COIL, CRANKSHAFT SENSOR,COIL,SPARK PLUG & WIRES S… read more
JHoop
JHoop
Owner,Technician
High School or GED
5,425 satisfied customers
98 chevy: It wont start... i made tests..cap, rotor, plugs, and wires
I have a 98 chevy silverado with the 5.7 litter engine.. It wont start... i made tests at the ign module and ign coil. which led me to believe the ign mod and pickup coil were bad... to be on the same… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
2001 chevy blazer: TACH..the crankshaft fail circuit code
I have a 2001 chevy blazer with 240 thos miles on it. I am having a issue, where when speeding up fast at take off the TACH goes crazy after 3 grand. It then throws the crankshaft fail circuit code. I… read more
Paul M ASE Master
Paul M ASE Master
Automotive College
4,537 satisfied customers
99 suburban: the camshaft position sensor..flywheel..chain
in order to remove the camshaft position sensor in a 99 suburban 5.7, do you have to remove the flywheel and harmonic balancer and the timeing chain cover in order to access to star screws for the sen… read more
goodwrench9124
goodwrench9124
Lead Tech/ Shop Leader
Vocational, Technical or Trade Scho
3,392 satisfied customers
GM: REbuilt..the cam 4 degrees for towing..dealership..distributor
REbuilt my 5.7 liter using stock cam but we advanced the cam 4 degrees for towing. Does this have ANY effect on the "cam retard offset" CRO setting? GM dealership told me my distributor is currently a… read more
goodwrench9124
goodwrench9124
Lead Tech/ Shop Leader
Vocational, Technical or Trade Scho
3,392 satisfied customers
1998 chevy tahoe: engine code..camshaft to crankshaft correlation
1998 chevy tahoe -engine code 1345-camshaft to crankshaft correlation-need suggestions to repair… read more
CCTMSTR
CCTMSTR
Technician
G.M Master Technician
202 satisfied customers
1998 chevy pickup with 5.7. removed the distributor to change
1998 chevy pickup with 5.7. removed the distributor to change head gasket. now getting code po1345 and runs hot 245degrees. have tried moveing distributor one tooth counterclockwise and one tooth cloc… read more
Billy
Billy
Shop Foreman
Vocational, Technical or Trade Scho
510 satisfied customers
1996 Chevy: module..disconnected..camshaft sensor harness..distributor
Pro tech: Had to replace an IC module on a 1996 Chevy 1500 PU. During the testing to find it I disconnected the camshaft sensor harness and turned the distributor. When all back do I need to use a Tec… read more
Ivan
Ivan
Automotive Instructor
Bachelor's Degree
4,857 satisfied customers
92 chevy: about 15 min, drove truck..mile..vibration..hood..wont start
92 chevy dully, 454, truck died like it was out of gas but it was not! let set over night and cranked right up next morning, ran the engine at idle for about 15 min, drove truck for about a 10th of a … read more
Ms. Wrench
Ms. Wrench
High School or GED
328 satisfied customers
1997 GMC: 2x4 1500 5.7..truck would keep trying to crank..worn..shims)
1997 GMC 2x4 1500 5.7. This truck would keep trying to crank with out the key. So I replaced the battery, starter and flywheel (flywheel worn by starter that didn't have shims). When I tryed to start … read more
skyjcky
skyjcky
owner ,lead tech
Vocational, Technical or Trade Scho
2 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

15,756 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,642 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,884 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

2,953 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Ron Z.

Ron Z.

- Chevy Tech -

2,836 satisfied customers

18+yrs experience. State Inspector and Chevy Diagnostics

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x