How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask GM Tech (Cam) Your Own Question
GM Tech (Cam)
GM Tech (Cam), Chevy Technician
Category: Chevy
Satisfied Customers: 15201
Experience:  GM Grand Master Technician 2007. 14 years experience.
10949255
Type Your Chevy Question Here...
GM Tech (Cam) is online now
A new question is answered every 9 seconds

Wiring harness for transfer case 4/4 1999 chev Tahoe. I

Customer Question

Wiring harness for transfer case 4/4 1999 chev Tahoe. I replace a new acuator, and new switch. Switch lights up. Power to the center pin on the actuator. Top off fuel in transfer case. Noticed wiring harness that had 6 wires one burnt into, spliced it back and taped. Two got hot put tape on them the other two is ok. Checked the transfer case sensor wires and cleaned. Checked the connection on the top left clean. Do I need to go to the number 13 pin using a wire and ground. TO check the fault code or just get a new wiring harness?
JA: Just to clarify, what are the exact lights you're talking about?
Customer: The switch lights tO to let you know if you are in 4/4 2h, auto, 4/4 h or low all light up but do not blink.
JA: Are you fixing your Tahoe yourself? What have you tried so far?
Customer: I foung
JA: Anything else you want the mechanic to know before I connect you?
Customer: found a 20 amp just drives side fuse panel it was good. Don't know if there are other fuses?
Submitted: 9 months ago.
Category: Chevy
Expert:  Tim's Auto Repair replied 9 months ago.

Hi, My name is ***** ***** for the delay.
I will do my best to assist you.

Expert:  Tim's Auto Repair replied 9 months ago.

i may have a wire diagram for this one..would that help you?