How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask AMEDEE Your Own Question
Category: Chevy
Satisfied Customers: 26420
Experience:  ASE certified tech ADVANCED LEVEL SPECIALIST. Wisconsin certified emissions state inspector
Type Your Chevy Question Here...
AMEDEE is online now
A new question is answered every 9 seconds

No reverse lights ALL FUSES are good, clear back up lights,

Customer Question

no reverse lights ALL FUSES are good
JA: Just to clarify, what are the exact lights you're talking about?
Customer: clear back up lights
JA: What is the model/year of your Chevy?
Customer: 07 Silverado 2500HD work truck model manual windows and everything
JA: Are you fixing your Silverado yourself? What have you tried so far?
Customer: yes checked all fuses all have power to them but no power at the lamp plug
JA: Anything else you want the mechanic to know before I connect you?
Customer: not that I can think of
Submitted: 1 year ago.
Category: Chevy
Expert:  AMEDEE replied 1 year ago.

Hello and welcome! My name isCustomerand I can assist you with your question. Can I start by getting your VIN? Thank you!

Customer: replied 1 year ago.
Expert:  AMEDEE replied 1 year ago.

Thank you for that information. Have you checked for codes in the computer?

Customer: replied 1 year ago.
no codes but it also has a back up beeper that doesn't come on any more either
Expert:  AMEDEE replied 1 year ago.

I would check to be sure that the body control module is powering up the back up lamp relay located in the underhood fuse block. This happens when the BCM gets a signal from the ECM over the BUS circuit. It is possible that the transmission range sensor, ECM or even the BCM is at fault. I bet there are codes stored in the BCM related to this problem. If not, then check for two powers and one ground going into the back up lamp relay with the transmission in reverse. Here is a wiring diagram.

Expert:  AMEDEE replied 1 year ago.

Hello! It'sCustomerfrom just answer.

I am just checking in to see if you need any further assistance?

Let me know!