How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Chevy
Satisfied Customers: 22670
Experience:  ASE Master and Advanced level certified. Factory trained with 15 years dealership experience
9825021
Type Your Chevy Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I just replaced my solo kid canister and check engine light

Customer Question

I just replaced my solo kid canister and check engine light is still on
JA: Does the light stay on, or does it blink?
Customer: Stays on
JA: What is the model/year of your Chevy?
Customer: 2010 Chevy impala
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: I replaced the canister
JA: Anything else you think the mechanic should know?
Customer: No
Submitted: 11 months ago.
Category: Chevy
Expert:  Ron Z. replied 11 months ago.

May I have the "p-code" that led you to replace the canister?

Customer: replied 11 months ago.
449 and 449pd now it's only 449pd
Expert:  Ron Z. replied 11 months ago.

Ok. Great. Give me a minute to load in your vehicle and grab some info. Be right back...

Expert:  Ron Z. replied 11 months ago.

Ok. The P0449 is a fairly straight forward code pointing to a problem with the EVAP Canister Vent Valve. It's located on the fuel filler neck (click here for image view: https://goo.gl/zMSVta). Carefully inspect the rubber lines for any cracks, holes or disconnections. Inspect the electrical connector and wire harness for any loose, broken or damaged wires. If the inspections check ok, replace the Canister Vent Solenoid. If you found this answer helpful, please help me by leaving a rating using the "stars" at the top of the page or click 'accept'.
Rating or accepting my answer does not cost you extra.

Customer: replied 11 months ago.
I replaced it and checked everything and it's not working
Expert:  Ron Z. replied 11 months ago.

Ok. We'll need to test the circuit. Do you have access to a test lamp?

Customer: replied 11 months ago.
No
Expert:  Ron Z. replied 11 months ago.

Ok. If the vent valve is not working, then the next step is to check the circuit. If you do not have access to a test lamp, then a careful inspection of the electrical connector and wire harness must be done. Look for any broken, damaged, rubbed-through wires.

Customer: replied 11 months ago.
It's secure no loose wires
Expert:  sprinkles08 replied 11 months ago.

Hello and welcome to JustAnswer!

Do you still need help?