Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Chevy Questions
Set CMP offset to 1 degree after distributor replacement,
Set CMP offset to 1 degree after distributor replacement, sets P1345 on a 96 Chevy 5.7 Vortec truck. … read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,022 satisfied customers
I have a 1986 Chevy Corvette, it will start for about 5
i have a 1986 Chevy Corvette, it will start for about 5 seconds and then it will die. It can not maintain idle. I have checked the timing by putting it on TDC and readjusting the distributor. no codes… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,022 satisfied customers
Chevrolet Tahoe Z71: Hey Pete..pulling what little hair I
Hey Pete..pulling what little hair I have left on this 2000 Tahoe Z71 350 vortec start issue. Intermittent start issue..there are times when it fires off great and stays running then times when it wil… read more
John
John
Associate Degree
641 satisfied customers
Chevrolet G30: Hi david, I have a 86 350 on my RV. I just bought
Hi david, I have a 86 350 on my RV. I just bought it so I don't know any previous work. The problem I have is that after ridding for several hours or during hot days the engine back fires and never re… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,642 satisfied customers
Chevrolet C1500 4x2: I have a 1996 Chevy C-1500 5.7 liter Vortec
I have a 1996 Chevy C-1500 5.7 liter Vortec V-8 350. my problem all started one day i was driving down the road and the truck just shut off while driving, it did not shutter stumble or anything just s… read more
Gary
Gary
Chevy Technician
Vocational, Technical or Trade Scho
9,642 satisfied customers
Chevrolet K1500 4x4: 1996 vortec, 350, chevy....... replaced
1996 vortec, 350, chevy....... replaced battery due to a cold snap in the weather, now it turns over, but sounds like it is advanced in timing, has good fire, and 58ish on fuel pressure, not codes set… read more
Master Tech Lee
Master Tech Lee
Automotive Diagnostic Repair Technician
Associate Degree
560 satisfied customers
temp sensor..bad module..new fuel pump rebuilt regulator checked
This in not going to be your everyday answer to this question...Because I have gone over all the usual normal things to look at on this one ...the last answer was the temp sensor must be defective but… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
Hey guys..99 silverado and I can get it to turn..wont fire..4th time
Hey guys and gals. I have a 99 silverado and I can get it to turn over but it just wont fire and start. Only after the 3rd or 4th time that I try starting it after turning it over and then completely … read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,756 satisfied customers
coolant leak on my truck..intake manifold..upper gaskets..distributor
Last week I had coolant leak on my truck. I spent this weekend looking for the leak and found it in the intake manifold gasket. I spent yesterday and today changing the upper gaskets on the truck. I m… read more
Dj
Dj
Auto Failure Analysis & Inspections
High School or GED
1,888 satisfied customers
1997 chevy truck: rotor..it wont start..exhaust when cranking
I have a 1997 chevy truck 350 vortec, I changed Distributor cap, rotor bug and cam position sensor and it wont start, it sounds like backfire through exhaust when cranking over, I have checked and rec… read more
Dave Nova
Dave Nova
Chevrolet Technician
Associate Degree
7,092 satisfied customers
1998 suburban: getting fuel..leak..put back..spark plug and it was wet
I have a 1998 suburban that will not start. I am getting fuel and I have a spark (a little weak) I fixed a leak in the exhaust pipe that was next to a sensor that I took out and put back in after the … read more
Jan Andersson
Jan Andersson
Master Tech
Bachelor's Degree
809 satisfied customers
Map..vacuum) this is a 86 monte ss, and the hei distributor
hey dave im back..so i installed the new board and my ses light works.you rock...now a new problem...i have trouble code 41, says posible short or loose connection, bad map sensor(but i dont get that … read more
Dave Nova
Dave Nova
Chevrolet Technician
Associate Degree
7,092 satisfied customers
1972 chevy: 4wd..distributor..aftermarket..a firewall-mounted coil
I have a 1972 Chev C10 Cheyenne Super, 4wd, 350/TH350. I want to change the distributor to an HEI. It has an aftermarket Mallory Unilite and a firewall-mounted coil now, that seems to give me trouble … read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,442 satisfied customers
73 Corvette: Jasper..300 hp and 363 ft-lbs of torque..exhaust is stock
Hi- I have a 73 Corvette and recently had a mechanic install a crate engine. It's a Jasper stock performance engine rated for 300 HP and 363 ft-lbs of torque. The exhaust is stock. The intake manifold… read more
AutoDoc
AutoDoc
Shop Owner
Bachelor's Degree
400 satisfied customers
I have a v8 with a holley pro-jection 2d tbi installed. It
I have a v8 with a holley pro-jection 2d tbi installed. It was running fine, but I had to put on a new intake manifold. Not just hits on about every other round and won't start. Checked timing, vacuum… read more
lazydog76
lazydog76
Auto Technician/ Firefighter-EMT
High School or GED
134 satisfied customers
1984 Chevy s10: head gasket..wont start..cranks..distributor is put
1984 Chevy S10 2wd 2.8L. I took the engine out and changed the head gasket, oil pan gasket, valve cover gasket, intake manifold gasket, and the oil pump seal. We got it all back together and everythin… read more
Tech Xpert
Tech Xpert
National Technical Consultant
Associate Degree
161 satisfied customers
Chevy S10: a 4.3L engine had a trouble code p1345 which..ckp..skipping
my chevy S10 truck with a 4.3L engine had a trouble code p1345 which said ckp/cmp correlation. the light has been on for a while and it has been running but skipping. now the vehicle just quit running… read more
tech364
tech364
Vocational, Technical or Trade Scho
196 satisfied customers
new intake..with #1 at tdc and the rotor pointing at #1 cylinder
i''ve just installed a new intake on my ''68 327. i dropped the distibutor back in with #1 at TDC and the rotor pointing at #1 cylinder. when starting the engine will fire but then die. I''ve checked … read more
John
John
Master A.S.E Automotive technician
2 YEARS COLLEGE
4,071 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

15,756 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

9,642 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,884 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

2,953 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Ron Z.

Ron Z.

- Chevy Tech -

2,836 satisfied customers

18+yrs experience. State Inspector and Chevy Diagnostics

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x