Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP
Hi there, I am cam. To bypass the ignition cylinder security sensor you need to install a resistor. This resistor needs to be a 2.2K ohm resistor , 1/4 watt or less is fine, installed between the yellow and orange black wire (ground). Make sure you cut the yellow wire at the ignition cylinder (small gauge in a cluster of 3). Then perform this relearn.
Turn the key on and attempt to start the car, It may crank, it may start and stall or it may do nothing at all, this is fine, still cycle the key to start then release the key back to run. Wait 10 minutes with the key in run. The passlock light should be flashing and the DIC will say "Service Vehicle" or "Security" or have a picture of a car with a lock during that 10 minute span.After 10 minutes has passed, turn off the car, count to 10, and try to start it again and release the key back to run.Wait another 10 minutes.After 10 minutes, turn car off 10 seconds and try to start again and release the key to run.Wait another 10 minutes.After 10 minutes, turn car off 10 seconds and try to start again.It should start up this time. The passlock has been learned.
During this process, turn the fans off, radio off and cycle the headlights off so the battery will not go dead. If needed, use a battery charger.