How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jared D Your Own Question
Jared D
Jared D, ASE Certified Technician
Category: Chevy
Satisfied Customers: 1914
Experience:  Shop Supervisor at County Fleet
62275574
Type Your Chevy Question Here...
Jared D is online now
A new question is answered every 9 seconds

Car won't start

Customer Question

Car won't start
Submitted: 2 years ago.
Category: Chevy
Customer: replied 2 years ago.
I have a salvaged engine that I installed.
I checked the gas and I am getting 55 lbs
Expert:  Jared D replied 2 years ago.

So it looks like you have good fuel pressure.

Have you been able to check for spark?

It cranks without any unusual noise?

Did you have to re-time the engine or was it just a straight swap?

Expert:  Jared D replied 2 years ago.

If you have a good scan tool:

Use a scanner to check for RPM during cranking.

If no RPM is shown, check the Crankshaft Position Sensor (CKP) for 460-620 ohms resistance and a sine wave output using a lab scope.

Check the CKP Dark Blue/White and Yellow/Black wires for opens or shorts.

Expert:  Jared D replied 2 years ago.

I just wanted to see if you needed any additional information. Also, I would appreciate a positive rating if I have been of any assistance. Thanks!