sorry for the delay............
Greetings...... “Hi, I’m Don (akaCustomer and I look forward to helping you!”
There is NO Customer Input for Programming Remote.
Use of Dealer Scan Tool & GM Computer is needed
•This procedure may be used with or without existing learned keys being present.
•This procedure will take more than 15 minutes to complete.
. This procedure will not learn any immobilizer information between the body control module (BCM) and engine
control module (ECM).
•If the battery voltage is low, charge the battery before continuing with the procedure.
1.Connect a GM scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) See: Testing and Inspection\Programming and Relearning\Service Programming System (SPS).
2.Ensure that all power consuming devices are turned OFF on the vehicle.
3.Select the SPS application and follow the on-screen instructions.
4.Select Reprogram ECU.
5.Select IMMO Immobilizer Learn.
6.Select the Program Transponder & Remote Key function
I understand that it may not be the answer you were hoping for, but please understand it is the only answer to your question.
It's a tough part of my job to relay bad news, but as I'm sure you understand, it's also my job to make sure I provide you with a truthful and accurate answer.
IF you need more information, please ask "prior" to Rating.
Please take a moment to rate my service so that I can get credit for my time.
NOTE: Do NOT Rate on how much TIME you waited, because I am not on 24 / 7 and I answer as soon as I see the question.
The question will still remain open for follow up questions if needed.
Rating is very Important to our Service