How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Eric Your Own Question
Eric
Eric, Automotive Repair Shop Manager
Category: Chevy
Satisfied Customers: 32090
Experience:  20+ yrs. experience as repair shop manager and technician.
3195632
Type Your Chevy Question Here...
Eric is online now
A new question is answered every 9 seconds

2003 chevy impala: ignition switch..LS...electrical issues..wont turn

This answer was rated:

I just installed a new ignition switch in a 2003 chevy impala LS. it fixed my problem with electrical issues but now the car will not start, everything lights up but it wont turn over. what do i need to do.

hi,

 

Ok, here is the relearn procedure you need to perform

 

When performing the 30-minute relearn procedure, all previously learned keys will be erased from the TDM memory. Additional keys may be learned after performing the relearn procedure.

 

  • With a master vehicle key, turn ON the ignition, with the engine OFF.
  • Observe the security indicator. After approximately 10 minutes, the telltale(security light) will turn OFF.
  • Turn OFF the ignition, and wait 5 seconds.
  • Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.

    Important: The vehicle learns the key transponder information and/or passwords on the ignition switch transition from OFF to RUN. You must turn the ignition OFF before attempting to start the vehicle.

  • With a master vehicle key, start the vehicle. The vehicle has now learned the key transponder information and/or the ECM has now learned the fuel continue password.
  • If additional keys are required to be learned:
  • Adding Keys

    Important:

    To initiate, this procedure requires that a learned master key be available.
    A total of 10 master keys or valet keys may be programmed to a single vehicle.
    This procedure adds keys only. The procedure does not erase previously learned keys.
    The keys to be learned must duplicate the mechanical cut of the current key.
    If more than one valet key is to be learned, immediately precede each valet key with a learned master key.

     

    1. With a previously learned master key, turn ON the ignition, with the engine OFF.
    2. Turn OFF the ignition and remove the key.
    3. Within 10 seconds insert the key to be learned. Turn ON the ignition with the engine OFF. The vehicle has now learned the new key.
  • Eric and 3 other Chevy Specialists are ready to help you