How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim's Auto Repair Your Own Question
Tim's Auto Repair
Tim's Auto Repair, mechanic
Category: Chevy
Satisfied Customers: 16029
Experience:  Have owned a repair shop for 25 yrs.
14541291
Type Your Chevy Question Here...
Tim's Auto Repair is online now
A new question is answered every 9 seconds

1990 Chevrolet Caprice Classic brougham: switch/turn signal lever

Customer Question

Hey Frank, I need to replace the multi-function wiper switch/turn signal lever on my 1990 Chevrolet Caprice Classic Broughm. How does it release from the switch portion at the end of the lever?
Submitted: 7 years ago.
Category: Chevy
Expert:  Tim's Auto Repair replied 7 years ago.

hi

frank don't seem to be on line

the handle should just unscrew by turning counter clock wise

thanks

 

Service and Repair

 













REMOVAL AND INSTALLATION OF TURN SIGNAL SWITCH:
Tools required:
J 23653-A Lock Plate Compressor
J 3568-A Terminal Remover

Remove or disconnect (Figures- 2,3,4,5,6,7)

NOTICE: Wheels of car must be straight ahead. Failure to do so may cause improper alignment during installation, resulting in column malfunction.

Key In "Lock" position. Failure to do will cause steering wheel to turn.

CAUTION: Disconnect battery. Failure to do me may cause electrical chock when working with wiring.

 

  1. Horn pad and electrical connection
  2. Retainer (1) and jam nut (2).
  3. Steering wheel using J-1859-03
  4. Shaft lock retaining spring (4) using J 2365-A to depress shaft lock (5)
  5. Shaft-lock (5) and shaft lock cover (3)
  6. Turn signal cancelling cam (6)
  7. Upper bearing spring (7)
  8. Upper bearing seat (12)
  9. Inner race (13)
  10. Turn signal to "right turn" position.
  11. Screw (9) and signal switch arm (10)
  12. Screws (8)
  13. To remove turn signal switch
    1. Wiring protector (54)
    2. Hazard knob
    3. Gently pull wire harness through column housing shroud (65) column housing (38), and lock housing cover (18).
14..Reverse procedure to install.
Customer: replied 7 years ago.
That's all been done. Where is the rest of step 13?
Expert:  Tim's Auto Repair replied 7 years ago.

lets try this

thanks

 

Fig. 9 Windshield Wiper Switch Removal (Front). Tilt Column