Chevy

Chevrolet Repair Questions? Ask a Chevy Mechanic for Answers ASAP

Ask an Expert,
Get an Answer ASAP!

Chevy

how do i remove the front seats on 2001 suburban

Customer Question
how do i remove the front seats on 2001 suburban
Submitted: 8 years ago.Category: Chevy
Ask Your Own Chevy Question
Answered in 4 minutes by:
7/11/2009
Chevy Mechanic: Gary, Chevy Technician replied 8 years ago
Gary
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 17,488
Experience: 15 years GM master tech
Verified

try this...let me know

 


Removal Procedure


Caution: Refer to SIR Caution in Service Precautions.

  1. If equipped with side air bags, disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Move the seat to the full rearward position. Remove the front seat nut cover (3), if equipped.
  3. Remove the seat retaining front nuts (2).
  4. Move the seat to the full forward position in order to remove the seat retaining rear bolts (1).
  5. Disconnect the electrical harness, if equipped.
  6. Remove the seat from the vehicle.

Installation Procedure

  1. Position the seat in the vehicle.
  2. Connect the electrical harness, if equipped. Notice: Refer to Fastener Notice in Service Precautions.
  3. Move the seat to the full forward position in order to install the seat retaining rear bolts (1). Tighten the retaining rear bolts to 55 N.m (41 lb ft).
  4. Install the front seat adjuster nut cover (3), if equipped.
  5. Move the seat to the full rearward position and install the seat retaining front nuts (2). Tighten the nuts to 55 N.m (41 lb ft).
  6. If equipped with side air bags, enable the SIR system. Refer to Enabling the SIR System in SIR.

 

 

 

© 2009 ALLDATA LLC. All rights reserved.
Terms of Use

Ask Your Own Chevy Question
Customer reply replied 8 years ago
how do you disable the SIR system?
Chevy Mechanic: Gary, Chevy Technician replied 8 years ago
remove the battery neg.cable off the battery..wait 10 mintues then unplug the airbag connectors
Ask Your Own Chevy Question
Customer reply replied 8 years ago
do you know what kind of wrenches i need to get those bolts off?
Chevy Mechanic: Gary, Chevy Technician replied 8 years ago
they should be 15 or 18 milimeter....i have seen some with inverted torx..
Gary
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 17,488
Experience: 15 years GM master tech
Verified
Gary and 87 other Chevy Specialists are ready to help you
Ask your own question now
Ask Gary Your Own Question
Gary
Gary
Gary, Chevy Technician
Category: Chevy
Satisfied Customers: 17,488
17,488 Satisfied Customers
Experience: 15 years GM master tech

Gary is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Chevy Technician

15,289 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

Chevy Technician

17,488 satisfied customers

15 years GM master tech

Tim&#039;s Auto Repair

Tim's Auto Repair

mechanic

8,866 satisfied customers

Have owned a repair shop for 25 yrs.

Dave Nova

Dave Nova

Chevrolet Technician

7,092 satisfied customers

ASE Master Certification. GM World Class Certification

John

John

Master A.S.E Automotive technician

4,071 satisfied customers

A.S.E MasterTechnician A1-A8 w/L1,38 years experience General Motors Master Technician

Don - Mo Lurch

Don - Mo Lurch

Auto Mech / Electronics

2,918 satisfied customers

Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

Ron Z.

Ron Z.

- Chevy Tech -

2,734 satisfied customers

18+yrs experience. State Inspector and Chevy Diagnostics

< Previous | Next >

Related Chevy Questions
MY 1997 CORVETTE WANT START AFTER I CHANGED THE STARTER N
MY 1997 CORVETTE WANT START AFTER I CHANGED THE STARTER N BATTERY N BOUGHT A NEW KEY … read more
Chris (aka - Moose)
Chris (aka - Moose)
Vocational, Technical or Trade Scho
108 satisfied customers
Headlights won't dim or shut off occasionally. 2014
I just got it started. The headlights stayed on and drained the battery. Earlier they wouldn't dim. They are off now, truck is running … read more
Chris (aka - Moose)
Chris (aka - Moose)
Vocational, Technical or Trade Scho
108 satisfied customers
2008 GMC 3500 Duramax Diesel wouldn'tnt start. No line under
2008 GMC 3500 Duramax Diesel wouldn'tnt start. No line under P but all lights on. Rocked to get line. Chalked tire to hold and start. Went down highway and after about 15 miles the engine quit. Would … read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,289 satisfied customers
Changed the thermostat & discovered a leaking problem.
Changed the thermostat & discovered a leaking problem. thought it was the housing gasket but it is a hose. The hose goes from the firewall to a port on back of block or head. I was changing the clamp … read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,289 satisfied customers
Chevy express 3500 6.5 turbo diesel, turn on key and "wait
Chevy express 3500 6.5 turbo diesel, turn on key and "wait to start" is illuminated. It goes out then flashes slowly on and ofd for 15 sec. or so. Is this flashing normal or a sign of a problem? Thank… read more
Kavey
Kavey
86 satisfied customers
I have spark and my fuel pressure is at 50 and a new fuel
I have spark and my fuel pressure is at 50 and a new fuel filter but will not start. … read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,289 satisfied customers
I have a 2002 chevy carla SS, 3800 engine, with a check
I have a 2002 chevy monte carla SS, 3800 engine, with a check engine light problem. Code showed 02 sencers. Changed both, cleared codes and drove it. After driving a little ways, check engine light is… read more
roy
roy
Associate Degree
3 satisfied customers
I have a 1995 Chevy K1500 4X4 with a 5.7L TBI engine with
I have a 1995 Chevy K1500 4X4 with a 5.7L TBI engine with 234,471 miles. It will not pass emissions due to high NOX. I was having problems with it prior to emissions testing and thought that I had mos… read more
AMEDEE
AMEDEE
AUTOMOTIVE TECHNICIAN
Vocational, Technical or Trade Scho
9,105 satisfied customers
1516 error code is appearing and getting reduced power mode,
1516 error code is appearing and getting reduced power mode … read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
4,393 satisfied customers
Cee i have 2008 trailblazer .i am having trouble with the
hello my name is ***** ***** i have 2008 trailblazer .i am having trouble with the wheel sensors .when connected the antilock keeps acting up … read more
Mechanic01
Mechanic01
1,645 satisfied customers
Was helping me with my heater head unit being dark and I
Roy was helping me with my heater head unit being dark and I wasn't checking the right wires for power between the two pin the 150 pin and the 50 and the 2 pin I have 14 volts going across all those p… read more
roy
roy
Associate Degree
3 satisfied customers
I have a loud tapping sound coming from my throttle body.
i have a loud tapping sound coming from my throttle body … read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
Our 2002 Chevy Silverado 1500 is having issues with the
Our 2002 Chevy Silverado 1500 is having issues with the security light flashing the truck will turn over but shuts off right away. … read more
AMEDEE
AMEDEE
AUTOMOTIVE TECHNICIAN
Vocational, Technical or Trade Scho
9,105 satisfied customers
Radio works intermittently, no display, no door chime, ECT.
Radio works intermittently, no display, no door chime, ECT … read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,289 satisfied customers
I installed new power steering box for CPP on a 1957 Chevy
I installed new power steering box for CPP on a 1957 Chevy truck, I thought I had everything right when I tried to drive it out of the shop as soon as I touched the wheel it started doing all kinds of… read more
don
don
fleet superintendent
Vocational, Technical or Trade Scho
12 satisfied customers
Background: I have a 2000 Chevy Silverado 1500 (with plow)
Background: I have a 2000 Chevy Silverado 1500 (with plow) used for on-property plowing that I'm letting a friend use on his property this winter. It doesn't see a lot of street/drive time - do some l… read more
GM Tech (Cam)
GM Tech (Cam)
Chevy Technician
Vocational, Technical or Trade Scho
15,289 satisfied customers
I have a 2011 equinox it ran fine yesterday now today it
Gary, I have a 2011 equinox it ran fine yesterday now today it will not start. It will turn over and try to fire but will not start unless you hold the gas to the floor. Once it starts it will run al … read more
Gary
Gary
Chevy Technician
17,488 satisfied customers
I have an 04 Tahoe, have been driving it for the last hour
I have an 04 Tahoe, have been driving it for the last hour and coming home two lights on the dash came on. One showed a lock and the other said no service availbility with a line through it. pulled ov… read more
Todd Audette
Todd Audette
Automotive Technician
Vocational High School
132 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x