How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don - Mo Lurch Your Own Question
Don - Mo Lurch
Don - Mo Lurch, Auto Mech / Electronics
Category: Chevy
Satisfied Customers: 21005
Experience:  Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.
1609972
Type Your Chevy Question Here...
Don - Mo Lurch is online now
A new question is answered every 9 seconds

WHERE IS THE TURN SIGNAL FLASHER FUSE LOCATED ON A 1998 CAMARO Z28?

Customer Question

WHERE IS THE TURN SIGNAL FLASHER FUSE LOCATED ON A 1998 CAMARO Z28?
Submitted: 9 years ago.
Category: Chevy
Expert:  Don - Mo Lurch replied 9 years ago.

 

Fuse # XXXXX in the inside Fuse Panel is the Turn Signal Fuse
graphic

 

The Turn Signal Flasher is located to the right of the steering column, under the dash.

REMOVAL PROCEDURE

  1. Remove the clip (1) from the instrument panel tie bar.
  2. Disconnect the turn signal flasher (2) electrical connector (3).
  3. Remove the clip (1) from the turn signal flasher (2).

INSTALLATION PROCEDURE

  1. Install the clip (1) to the turn signal flasher (2).
  2. Connect the turn signal flasher (2) electrical connector (3).
  3. Install the clip (1) to the instrument panel tie bar.
Don - Mo Lurch and other Chevy Specialists are ready to help you
Customer: replied 9 years ago.
That was not I was looking for. I need to know where the flasher is not the fuse.
Expert:  Don - Mo Lurch replied 9 years ago.

Your question:
WHERE IS THE TURN SIGNAL FLASHER FUSE LOCATED ON A 1998 CAMARO Z28?

??

Please read my answer above in it's entirety:

It also tells you where the Falsher is located & how to get to it

The Turn Signal Flasher is located to the right of the steering column, under the dash.

Customer: replied 9 years ago.
Reply to Lurch's Post: now the back signals are working but the front are not.

Any suggestions?
Expert:  Don - Mo Lurch replied 9 years ago.
Be sure all bulbs are good.
Be sure there is Voltage at the Bulb with Signals on.
If not voltage to bulb, then you will need to check the Turn Signal Switch (multi-function switch). That is usually the cause if no voltage at the bulbs